Geely Emgrand X7. Manual part — 561
Geely Emgrand X7. Manual part - 561
assembly.
9. Install indoor rearview mirror.
10. Install the ventilation cover plate.
11. Install the wiper arm.
2243
11.5.8.14Back glass replacement
Dismantlement procedure
1. Dismantle battery negative cable, Refer to 2.11.8.1 Disconnect connecting process of battery
cable
2. For dismantling of rear wiper
arm, refer to 11.5.8.3
Replacement of rear wiper arm.
3. For dismantling of back door
trimming plate, refer to 12.9.1.10
Replacement of back door
trimming plate.
4. Disconnect high-mounted brake
lamp wire harness connector.
5. Disconnect the rear defrosting
harness connector.
NL11-0071b
6. Cut out the glazing compound
around the back door window
with a fine steel wire.
Notes:
Both ends of thin steel wire are wound
with wood blocks, which is operated
by two persons to facilitate
disassembling.
7. Remove the back door window
from the back door window
frame.
Notes:
Two persons need to complete the step
jointly.
8. Remove the adhesive on the back
door window with a knife blade.
9. Remove the adhesive on the back
door window frame with a knife
blade.
10. Clean the inner surface edge of
windshield with a cloth stained
soaked with industrial ethanol
and water mixture50/50.
NL11-0072b
2244
Installation procedure:
1. Open the dedicated Geely glass
sealant nozzle to make the edge
of glass sealant is with a width of
8 mm (0.3in) and a height of 8
mm (0.3in).
NL11-0069b
2. With a double-pipe gun evenly
apply glass sealant to the edge of
window glass to make sure that
the width of sealant is even.
3. With the help of assistant, use
sucker to install back door glass
into vehicle body rear windshield
frame.
4. Press back door glass, and then
apply adhesive tape on back door
glass and rear windshield glass
frame to fix back door glass.
5. Make the adhesive stay dry for
24h.
6. Spray water to the back door
window to check for leakage. If
leaking water, dry the back door
and plug the leakage part through
glazing compound. If still leaking
water, dismantle the back door
glass and repeatedly execute the
whole maintenance procedure.
NL11-0070b
2245
7. Connect the rear defrosting
harness connector.
8. Connect the high mounted brake
lamp harness connector.
9. Install rear wiper arm
10. Install the back door trim panel.
11. Connect the battery negative
cable.
NL11-0071b
2246
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст