Geely Emgrand X7. Manual part — 627
Geely Emgrand X7. Manual part - 627
Test terminal
Test conditions
Standard voltage
A—B Forward 11-14V
B—A Forward 11-14V
Confirm whether the terminal voltage accords with the standard value?
4
Replace power seat adjusting switch,
(a) Replace power seat adjusting switch. Refer to 11.9.8.3 Power seat adjuster assembly
replacement.
Confirm whether the electric seat works normally.
5
Check power seat backrest adjusting motor
(a) Operate electric seat front and rear adjusting switch.
(b) Meanwhile, use multimeter to measure voltage between electric backrest adjusting motor
wire harness connector terminal No. 1 and No.2.
Test terminal
Test conditions
Standard voltage
1—2 Forward
11-14V
1—2 Forward
11-14V
Confirm whether the terminal voltage accords with the standard value?
6
Inspect the circuit between the electric seat regulating switch and the electric seat back
regulating motor as well as between the back regulating switch and the effective body
grounding point.
(a) Inspect circuit between electric seat adjusting switch and backrest adjusting motor, between
backrest adjusting switch and vehicle body effective grounding point.
(b) Cut off fault point for cutting broken circuit.
Yes
Go to step 7
No
Yes
The system is normal.
No
Yes
Go to step 5
No
2507
Confirm whether the electric seat works normally.
7
Replace backrest adjusting motor
(a) Replace Power seat backrest adjusting motor. Refer to11.9.8.3 power seat adjuster assembly
replacement.
Confirm the completion of repair.
8
The system is normal.
Next
Yes
The system is normal.
No
2508
11.10.8 Dismantle and install
11.10.8.1 Front power seat replacement
Dismantlement procedure
Warning!
Warning: refer to warning on battery
disconnection in warnings and
precautions.
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 battery
cable disconnection/connection
procedures.
2. Dismantle front end lower
protective cover 1 of electric seat.
3. Dismantle fixing bolt 2 on the
front of electric seat.
1
1
2
2
NL11-0403b
4. Dismantle lower protective cover
1 on the rear of electric seat.
5. Remove Fixing Bolt 2 on the
back of the power seat.
1
2
1
2
NL11-0404b
6. Disconnect the harness connector
at the bottom of the power seat.
NL11-0405b
2509
7. Move out Power seat.
NL11-0406b
Installation procedure:
1. Install the power seat.
2. Connect electric seat adjusting
bottom wire harness connector.
NL11-0405b
3. Install
electric seat front fixing
bolt.
Torque: 45Nm (Metric) 33. 3 lb-ft
(English system)
NL11-0407b
2510
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст