Geely Emgrand X7. Manual part — 450
Geely Emgrand X7. Manual part - 450
4. Install high-pressure pipe hard joint bolt under
condenser and tighten it.
NL08-0053b
5. Install and tighten the bolt between the hard
connector of the high pressure pipe from the
compressor to the condenser.
NL08-0055b
6. Install and tighten the A/C low pressure pipe
rigid connector bolt on the compressor's side.
7. Install the A/C pressure switch.
8. Assemble
expansion
valve
9. Install
front
bumper.
10. Operate filling procedures of A/C refrigerant.
11. Connect the battery negative cable.
NL08-0051b
1799
Replacement of Heater Pipe
Dismantle procedure
1. Drain
engine
coolant.
2. Loosen fixing snap ring of warm air water pipe.
3. Dismantle warm air water pipe.
NL08-0057b
Installation procedure:
1. Install heat air water pipe.
2. Tighten fixing snap ring of warm air water pipe.
3. Fill engine coolant.
NL08-0057b
1800
8.3.8.17 A/C venting pipe replacement
Dismantle procedure
1. For dismantling of upper cover of instrument
table, refer to 12.8.3.1 Replacement of instrument
panel.
2. Dismantle left and right inner bracket of vent
pipe and defrosting pipe.
3. Dismantle 4 fixing screws of defrosting pipe.
4. Dismantle defrosting pipe.
NL08-0059b
5. Remove 4 fixing screws for the ventilation pipe.
NL08-0060b
6. Remove the 4 fixing screws inside and at the
bottom of the ventilation pipe.
NL08-0061b
1801
7. Dismantle the A/C ventilation pipe.
NL08-0062b
Installation procedure:
1. Install A/C vent pipe.
2. Install 4 fixing screws respectively in vent pipe
and lower section.
NL08-0061b
3. Install 4 fixing screws of vent pipe and tighten
them.
NL08-0060b
1802
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст