Geely Emgrand X7. Manual part — 308
Geely Emgrand X7. Manual part - 308
7. Pull out 5th speed gear and4th speed gear by
special tool “bearing puller“.
FE03-0116b
8. Take out 4th speed gear and 3rd speed gear
bushing.
FE03-0117b
9. Pull out 3rd speed gear by special tool bearing
puller.
Notes :Gap is too small between 3rd speed gear and
2nd speed gear, May separately pull out 3rd speed
gear from a distance,
FE03-0118b
1231
10. Take out 2nd speed gear, bearing and bearing
retaining ring.
Notes : the needle bearing has opens to directly take
out
!
FE03-0119b
11. Take out 1st/2nd speed synchronizer snap spring
by snap ring pliers
FE03-0120b
12. Take out 1st/2nd speed synchronizer
Notes :distance between gear bushing and shift
fork 0,35mm( 13,
≦
≦
780 in×10
-3
)
FE03-0121b
1232
13. Take out 1 speed gear
FE03-0122b
14. Take out 1st speed gear needle bearing.
Notes: the needle bearing has opens to, can not
dismantle by big force, otherwire may cause this
bearing!
FE03-0123b
15. Completed final status after dismantle main
shaft.
Notes : Worn condition of main shaft:Min,diameter is
33,985mm(1337,989 in×10
-3
)main bearing radial
runout 0,03mm( 1,181 in×
≦
≦
10
-3
)
FE03-0124b
1233
Installation procedure::
1. Install 1st speed gear needle bearing.
FE03-0125b
2. Install the 1st speed gear.
FE03-0126b
3. Install1st/2nd
speed
synchronizer.
Notes: gear surface face the rear-end of
transmission
4. Install1st/2nd speed synchronizer snap spring .
FE03-0127b
1234
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст