Geely Emgrand X7. Manual part — 251
Geely Emgrand X7. Manual part - 251
4. Install the intake and exhaust
camshaft cover.
There are letters on the camshaft
cover. Avoid installation errors. For
example, "I ↑ 2" indicates that the
camshaft cover is the No.2 intake
camshaft cover. The arrow is toward
the direction of timing chain. E ↑ 2
indicates the No.2 exhaust camshaft
cover. The arrow is toward the
direction of timing chain.
FE02-0183b
5. Tighten camshaft cover bolts in
the order as showed in the figure.
Note: Tighten the bolts during
several stages. Do not tighten at once
which may damage the camshaft and
the camshaft cover.
Torque :M6 bolt
13N.m(Metric)10lb-ft(English
system)
M8 Bolt
23 N.m(Metric)17lb-ft(English
system)
3
1
6
8
9
7
11
5
2
4
10
FE02-0184b
6. Install the exhaust camshaft
sprocket.
Note: Inspect the sprocket pin wear.
If there is wear, replace the sprocket
pin. Hold the camshaft with a wrench
and then tighten the VVT actuator
bolts.
Torque :55N . m(Metric)
41lb-ft(English system)
FE02-0185b
1003
7. Install the intake camshaft VVT
actuator.
Note: Inspect the VVT actuator pin
wear. Hold the camshaft with a
wrench and then tighten the sprocket
bolts.
Torque :70N . m(Metric)
52lb-ft(English system)
8. Install timing chain
9. Install the timing chain cover.
10. Install the drive belt.
11. Install the cylinder hood cover.
12. Install the plastic shield of
engine.
13. Connect battery negative cable.
FE02-0186b
1004
2.13.8.13 Replacement of Engine
Dismantlement Procedure
1. Dismantle battery negative cable,refer to 2.11.8.1 Disconnect connecting process of battery
cable
2. Release the fuel pressure. Refer to 2.3.8.1 Fuel Pressure Release Procedure.
3. Discharge engine coolant. Refer to 2.8.8.1 Engine Coolant Discharge and Filling.
4. Refer to 2.8.8.2 "Replacement of
Coolant Recovery Reservoir" to
dismantle the coolant recovery
reservoir.
5. Recover the air-conditioning
refrigerant. Refer to 8.2.7.12
Air-conditioning Refrigerant
Recovery and Filling.
6. Remove battery base plate, Refer
to 2.11.8.2 Battery Replacement.
7. Refer to 12.8.3.3 "Replacement
of Glove Box of the Instrument
Panel" to dismantle the glove
box of the instrument panel.
8. Disconnect the engine control
unit and engine harness to the
instrument panel harness
connectors.
NL02-0171b
9. Pull the engine harness out of
the firewall.
NL02-0172b
1005
10. Disconnect front and rear
oxygen sensor wiring harness
connectors.
NL02-0173b
11. Dismantle the air-conditioning
compressor high and low
pressure connecting tubes.
NL02-0174b
12.
Dismantle intake air pipe
assembly.
NL02-0175b
1006
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст