Geely Emgrand X7. Manual part — 98
Geely Emgrand X7. Manual part - 98
2.5.7.8 Ignition Key Erase
1
Insert the new key.
2
Turn the ignition switch to the position "ON".
3 Enter
Anti-theft
System
Note: Before enter the security code please contact the manufacturers technical department, as
the Anti-theft computer will be locked after the wrong security code entered seven consecutive
times.
4
Enter the security code.
5
Key erasing: Choose the previously recorded key positions and erase them, If all
erasing is enabled, all keys will be disabled.
6
Place the ignition switch at "OFF" position and wait about 5 min or so.
7
Key erase successfully.
Next
Next
Next
Next
Next
Next
391
2.5.7.9 Replaced Security Module Programming
1
Insert the new key.
2
Turn the ignition switch to the position "ON".
3 Enter
Anti-theft
System
Note: Before enter the security code please contact the manufacturers technical department, as
the Anti-theft computer will be locked after the wrong security code entered seven consecutive
times.
4
Set the security code.
5
Enter the security code (the preset four-digit security code).
6
Read the ECM to the anti-theft module.
7
Refer to 2.5.7.7 “Replaced Key Programming” to reprogram the key.
Next
Next
Next
Next
Next
Next
392
2.5.7.10 Replaced ECM Programming
1
Insert the new key.
2
Turn the ignition switch to the position "ON".
3 Enter
Anti-theft
System
Note: Before enter the security code please contact the manufacturers technical department, as
the Anti-theft computer will be locked after the wrong security code entered seven consecutive
times.
4
Enter the security code.
5
Read the anti-theft module to ECM.
Next
Next
Next
Next
393
2.5.7.11 Replaced Anti-theft Module and ECM Programming
If the anti-theft controller and EMS controller need to be replaced at the same time, the
matched transponder should be replaced at the same time, otherwise the anti-theft system
matching can not be achieved. After replacement, the anti-theft system should be matched
again.
1
Insert the new key.
2
Turn the ignition switch to the position "ON".
3 Enter
Anti-theft
System
Note: Before enter the security code please contact the manufacturers technical department, as
the Anti-theft computer will be locked after the wrong security code entered seven consecutive
times.
4
Set security code (Provided that the anti-theft module is new and without preset
security code).
5
Enter the security code (the preset four-digit security code).
6
Read the anti-theft module to ECM.
7
Read the ECM to the anti-theft module.
8
Refer to 2.5.7.7 “Replaced Key Programming” to reprogram the key.
Next
Next
Next
Next
Next
Next
Next
394
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст