Geely Emgrand X7. Manual part — 295
Geely Emgrand X7. Manual part - 295
A. Disconnect transmission shift control guy cable
and transmission control.
B. Operate the shift lever. check if the shift control
cable can stretch freely and easily.
C. Transmission shift lever selectional force is <8 N
(1.8 LB), shifting force is<4 N (0.9 LB).
Transmission shift control travel should meet the
range shown in the figure.
16
16
8.8
8.8
NL03-2015b
4
Inspect transmission shift control cable movement.
A. Disconnect the transmission shift lever and the transmission control guy cable.
B. Check if the transmission control guy cable is difficult to stretch or broken.
5
Replace Transmission shift lever
3
Check transmission shift lever shift force and travel
Repair or replace worn transmission shift
control mechanism or the fork
No
Yes
Adjust or replace shift control cable;
Overhaul or replace clamping stagnation
transmission shift control mechanism or fork
mechanism
Yes
No
Replace the transmission shift control cable.
Yes
No
1179
A. Whether tranmission shifting problem is resolved.
6
Inspect the clutch
A. With the engine running, transmission is placed in neutral gear.
B. Step on the clutch pedal to the end, check if the lever can easily engage or disengage the reverse gear.
7
Check fault position
A. Step on the clutch pedal to the end. Try each forward gear to identify the faulty gear.
B. Disassemble the transmission. Check if the faulty gear synchronizers or gears are damaged.
C. Replace the fault of all the synchronizer or the gear
D. Make sure that the repair work is finished.
8
The system is normal.
No
Yes
The system is normal.
Check clutch,
Check replace reverse
Yes
No
Next
1180
3.4.7.4 Out of gear
The table below describes possible fault position s. check each part, and replace them if necessary.
Symptoms Suspected
parts
Referance
1. Engine support
Engine support replacement
2. Transmission gearshift Lever
3.1 control system
3. Transmission shift control guy wire
3.1 control system
4. Transmission
shift
control
mechanism
3.4.8 Dismantle and installation
Out of gear
5. Gearshift fork and lock mechanism
3.4.8 Dismantle and installation
Diagnostic procedures:
1
Check the transmission and the engine mount
A. When engine is running, whether there is serious jitter.
B. Serious jitter will cause the engine stall.
2
Check Transmission shift control system.
A. Whether the connection between transmission shift control guy cable and the transmission shift control
mechanism is firm.
B. Whether the connection between the shift lever and the transmission control guy cable is firm.
3
Check transmission gear self-locking nut
Yes
Tighten or replace the transmission and engine
support.
No
Tighten or replace transmission shift control
cable or transmission shift control rod.
Yes
No
1181
A. Whether the gear self-locking nut is installed
correctly.
FE03-2021b
4
Replace the shift control mechanism.
,A. Dismantle the transmission shift control mechanism to inspect for wear and tear or deformation.
5
Inspect the faulty gear fork locking pin.
A. Dismantle
the
transmission.
B. Disassemble the transmission. check the shift fork for deformation.
C. Replace the damaged shift fork.
D. Make sure that the repair work is finished.
6
The system is normal.
Tighten or replace the gear
No
Replace the shift control mechanism of
transmission
No
Yes
Next
No
1182
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст