Geely Emgrand X7. Manual part — 691
Geely Emgrand X7. Manual part - 691
10. Install trimming covers on both sides of right
front safety handle. The installation of the left
rear and right rear safety handles is the same.
11. Install interior reading lamp .
12. Install Rear post trim plate
13. Install middle column trimming plate.
14. Install front column trimming plate.
15. Install doorsill inner trimming plate of four-door
vehicle.
16. Connect the battery negative cable.
NL12-0190b
2763
12.9.1.12 Indoor carpet replacement
Dismantlement Procedure
Warning!
Warning: Refer to Warning on Battery Disconnection in Warnings and Precautions.
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery Cable Disconnection/Connection Procedures.
2. For dismantling of left, right front row seat, refer to
12.7.3.2 Replacement of front row seat
.
3. For dismantling of left and right middle row seats, refer to
12.7.3.4 Replacement of middle row seats.
4. For dismantling of auxiliary instrument table assembly, refer to
12.8.3.2 Replacement of auxiliary instrument
panel.
5. For dismantlement of the left/right internal threshold trim panel, see
12.9.1.1 Replacement of Left/Right
Front Threshold Internal Trim Panel Assembly.
6. For dismantlement of lower trim panels for left and right center pillars, see
12.9.1.3 Replacement of Center
Pillar Trim Panels.
7. For dismantlement of the rear pillar top trim panel, see
12.9.1.6 Replacement of Rear Pillar Top Trim Panel.
8. For dismantlement of the right intermediate seat belt lock catch assembly, see
9.3.7.5 Replacement of 2nd
Row Right Seat Belt Lock Catch.
9. Remove the in-vehicle carpet.
Installation Procedure:
1. Install the passenger compartment floor carpet.
2. Install left / right middle row seat
3. Install left and right front row seats.
4. Install right safety belt buckle assembly of middle row seat.
5. Install the trim panel for the boot.
6. Install the left and right lower center pillar trim panels.
7. Install the left/right threshold internal trim panel.
8. Install the floor console assembly.
9. Connect the battery negative cable.
2764
12.10 Exterior trim
12.10.1 Dismantle and install
12.10.1.1 Front/rear logo front/rear replacement
Dismantlement Procedure
1. Dismantle logo on the front of vehicle by using
slotted screwdriver.
Notes:
The screwdriver port is covered by the adhesive tape
to protect the parts.
NL12-0191b
Installation Procedure:
1. Use a special cleaning solution to clean the front
emblem attached surface.
2. Install logo on the front of vehicle to the
specified position.
Notes:
For the method for replacing the logo on the tailing of
the body, refer to the method for replacement of the
logo on the head of the body.
NL12-0192b
2765
12.10.1.2 Engine hood sound insulation cushion replacement
Dismantlement Procedure
1. Dismantle the retaining clips for engine hood
interior trim panel, and dismantle the sound
insulation pad.
NL12-0193b
Installation Procedure:
1. Install engine cover inner trimming plate buckle,
and fix sound insulation pad.
NL12-0193b
2766
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст