Geely Emgrand X7. Manual part — 597
Geely Emgrand X7. Manual part - 597
A. Connect fault diagnosis tester to the data link connector.
B. Rotated ignition switch to ON position.
C. Clear DTC code.
D. Start and run the engine at idle speed to warm up the engine for at least 5min.
E. Read the control system DTC code again.
DTC codes still exist?
4 Troubleshooting
11.7.7.6 DTC U1400 U1410 U1420 U1430 U1501 U1601
DTC code
Descriptions
U10018
A/C message time-out and lost communication with A/C
U10017
BCM message time-out and lost communication with BCM
U10011
CAN network system integrity test failure
U10010
Detect CAN BUS off state.
Diagnostic steps:
See 11.16.8 Diagnostic Information and procedures in "data communication system".
3
Use fault diagnosis tester to confirm if DTC is stored again.
Yes
Go to step 1
No
2387
11.7.8 Dismantle and install
11.7.8.1 Replacement of combination instrument assembly
Dismantlement procedure
Warning!
Warning: refer to warning on battery
disconnection in warnings and
precautions.
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 battery
cable disconnection/connection
procedures.
2. Dismantle combined instrument
cover.
NL11-0203b
3. Dismantle fixing screw of
combined instrument.
NL11-0204b
4. Disconnect combined instrument
wire harness connector.
NL11-0205b
2388
Installation procedure:
1.
Connect the combination
instrument harness connector.
NL11-0206b
2. Install and tighten fixing screw of
multi-functional instrument.
Torque :4Nm(Metric) 3lb-ft(English
system)
NL11-0204b
3. Install combined instrument
cover.
4. Connect the battery negative
cable.
NL11-0207b
2389
11.7.8.2 Replacement of combination adjustment switch
Dismantlement procedure
Warning!
Warning: refer to "warning on battery
disconnection" in "warnings and
precautions".
1. Disconnect the battery negative
cable. Refer to 2.11.8.1 battery
cable disconnection/connection
procedures.
2. Dismantle the instrument panel
center switch assembly. Refer to
8.2.8.1 Replacement of
Air-conditioning Control Panel.
3. Remove instrument adjusting
switch from central switch
assembly of instrument panel.
NL11-0208b
Installation procedure:
1. Install instrument adjusting
switch onto instrument panel
central switch.
2. Install the instrument panel center
switch.
3. Connect the battery negative
cable.
NL11-0208b
2390
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст