Geely EC718, EC718RV, EC715, EC715RV. Manual part — 423
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 423
FE11-0360b
16. Connect the rear door window switch wiring harness
connector.
17. Install the rear door trim panel clips.
18. Install the rear door trim panel.
19. Tighten the rear door trim panel retaining screw.
Torque: 2 Nm (Metric) 1.5 lb-ft (US English)
20. Install the rear door armrest retaining screw cover.
21. Install the rear door handle retaining screw cover.
11.5.8.8
Window
Regulator
Module
Replacement (If equipped)
Removal Procedure
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
FE11-0361b
1.
Disconnect the battery negative cable. Refer to
.
2.
Remove the left front seat. Refer to
.
Body Electric
Glasses / Windows / Mirrors
11-205
FE11-0362b
3.
Disconnect the power window module harness connector.
Installation Procedure:
FE11-0363b
1.
Install the window regulator module retaining bolts.
Torque: 15 Nm (Metric) 11 lb-ft (US English)
FE11-0364b
2.
Connect the window regulator module harness connector.
3.
Install the left front seat.
4.
Connect the battery negative cable.
11-206
Glasses / Windows / Mirrors
Body Electric
11.5.8.9 Windshield Replacement
Removal Procedure
FE11-1801b
1.
Remove the wiper arms. Refer to
2.
Remove the air inlet duct.
3.
Remove the left / right front A pillar garnish moldings.
Refer
to
4.
Remove the inside rearview mirror. Refer to
Inside Rearview Mirror Replacement
.
5.
Remove the seal around the windshield.
FE11-1802b
6.
Cut the windshield glass adhesive with a thin steel wire.
Note
Wrap both end of the fine steel wire around a wood
handle, operate by with two people to facilitate the
removal. Place a piece of plastic on the instrument
panel to protect the instrument panel.
FE11-1803b
7.
Remove windshield from the frame.
Note
It takes two people to complete this step.
Body Electric
Glasses / Windows / Mirrors
11-207
FE11-1804b
8.
Remove the glue residue on the windshield with a blade.
9.
Remove the glue residue on the windshield frame with a
blade.
10. Clean the windshield inner surface with a cloth stained
soaked with industrial ethanol and water mixture with
50/50 volume ratio.
Installation Procedure:
FE11-1805b
1.
Apply the new glass seal strip to the windshield.
FE11-1806b
2.
Spray the dedicated Geely glass sealant, with 8 mm (0.3
in) Width 8 mm (0.3 in) height.
11-208
Glasses / Windows / Mirrors
Body Electric
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст