Geely EC718, EC718RV, EC715, EC715RV. Manual part — 73
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 73
FE02-0006b
3.
Connect the idle speed control valve wiring harness
connector.
4.
Connect the battery negative cable.
2.2.8.2 Fuel Injector Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnection Warning" in the
"Warnings and Notices".
FE02-0023b
1.
Release fuel system pressure. Refer to
2.
Disconnect the battery negative cable. Refer to
.
3.
Remove the hood. Refer to
4.
Disconnect the crankcase ventilation tube.
FE02-0024b
5.
Disconnect the fuel injector wiring harness connector.
Note
Pull up the connector gray part of the self-locking
device, and then press down to Disconnect the
connector.
Engine
Control System JL4G18-D
2-207
FE02-0025b
6.
Remove the fuel pipe from the fuel rail.
FE02-0026b
7.
Remove the fuel rail retaining bolts.
FE02-0027b
8.
Remove the fuel rail and fuel injector assembly.
Note
Plug four fuel injector holes immediately after
removal to prevent debris falling into the cylinder
causing engine damage.
2-208
Control System JL4G18-D
Engine
FE02-0028b
9.
Remove fuel injectors retaining clips.
FE02-0029b
10. Pull fuel injectors out of the fuel rail.
Installation Procedure:
FE02-0030b
1.
Apply a small amount of engine oil to lubricate the fuel
injector O-ring.
2.
Install the fuel injectors to the fuel rail.
Note
The fuel injector terminals should face outside.
Engine
Control System JL4G18-D
2-209
FE02-0031b
3.
Install fuel injector retaining clips to ensure that the fuel
injector wiring harness connector and the fuel rail
mounting hole are in the same direction.
FE02-0032b
4.
Install the fuel rail.
FE02-0033b
5.
Install the fuel rail retaining bolts.
Torque: 9 Nm (Metric) 6.66 lb-ft (US English)
2-210
Control System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст