Geely EC718, EC718RV, EC715, EC715RV. Manual part — 464

FE11-0544b

3.

Disconnect the rear compartment lid release switch wiring
harness connector.

FE11-0545b

4.

Release the rear compartment lid release switch clip and
remove the rear compartment lid release switch.

Installation Procedure:

FE11-0546b

1.

Install the rear compartment lid release switch in to the
dimmer switch panel.

Body Electric

Central Locking

11-369

FE11-0547b

2.

Connect the rear compartment lid release switch wiring
harness connector.

FE11-0548b

3.

Install the dimmer switch.

4.

Connect the battery negative cable.

11-370

Central Locking

Body Electric

11.10 Remote Anti-theft System

11.10.1 Specifications
11.10.1.1 Fastener Tightening Specifications

Applications

Model

Specifications

Metric (Nm)

US English (lb-ft)

BCM Retaining Bolts

M8 × 16

8-11

6-8

Body Electric

Remote Anti-theft System

11-371

11.10.2 Description and Operation
11.10.2.1 Description and Operation

Remote anti-theft system is an auxiliary vehicle alarm device.
The alarm system is triggered when there is a forcible intrusion.
The system is used in conjunction with the central locking
system. Radio frequency interference or run out of battery
power can make the system inoperative. Remote anti-theft
system allows the operation of the following components.

–

Door Lock

–

Anti-theft Horn

–

Turn Signal

Remote anti-theft system consists of the following main
components:

–

Transmitter (Remote Control Key)

–

RF Receiver (BCM)

–

Door Contact Switch

–

Hood Ajar Switch

–

Rear Compartment Lid (Hatchback) Contact Switch

When the button on the transmitter is pressed, the transmitter
sends a signal to BCM. Then, BCM implements the
corresponding functions.

Remote Anti-theft

Remote anti-theft system operates independently from the
engine anti-theft system. Remote anti-theft system is designed
to sound the alarm when a door, the rear compartment lid or
the engine hood is forced open. In the alarm system, the alarm
horn will sound intermittently, while turn signal lamps will flash.
After 30 s, the horn will stop working, only turn signal lamps
flash 5 min. When all doors are closed, the alarm will continue
to sound for 30 s. After 30 s, the horn and the lamps will stop
and the doors are locked, the system returns enabled. Remote
anti-theft system will not affect the engine to start or work
properly.

Rolling Code

Remote anti-theft system uses rolling code technology. The
technology prevents any person recording the message sent

from the transmitter and use the information to get into the
vehicle. The term "Rolling Code" indicates the way the remote
anti-theft system sending and receiving signals. Transmitter
transmits signals in different order each time. Transmitter and
RF receiver synchronize according to the corresponding order.
If a programmed transmitter sending a signal that is not
consistent with the RF expected signal, the synchronization will
fail. This usually occurs when the vehicle remote control
transmitter button is pressed outside the 255 times range.

Remote Control Door Lock

–

When the ignition key is not inserted, press the unlock
button on the remote control, four doors unlock, turn signal
lamps flash.

–

When the ignition key is not inserted, press the lock button
on the remote control, four doors lock, turn signal lamps
flash.

Anti-theft Activated

–

When the ignition key is pulled out, close all doors / rear
compartment lid / engine hood with remote control door lock
(press lock button once), turn signal lamps flash once. The
anti-theft mode will be activated in 3 s.

–

Automatic locking, the anti-theft mode will be activated
automatically.

Anti-theft Activation Failure

Using the remote control lock button to lock the doors, but if
any door / rear compartment lid / engine hood is not closed
properly, turn signal lamps will flash 3 times, the anti-theft horn
will sound twice, 2 s each time, in 10 s, the anti-theft alarm will
be activated (alarm loop is as following: left and right turn signal
lamps flash, anti-theft alarm horn sound, after 30 s the horn will
stop working, only the left and right turn signal lamps flash 5
min). If in 10 s, the lock button is pressed, the anti-theft alarm
will not be activated, but the system will still be in anti-theft
mode (If no other trigger conditions, horns will not sound and
turn signal lamps will not flash). In the anti-theft alarm mode, if
the remote control unlock key is pressed, it will stop the alarm
loop, and the anti-theft status will be lifted. If the lock button is
pressed again, the system will resume its original status. As
shown below:

11-372

Remote Anti-theft System

Body Electric