Geely EC718, EC718RV, EC715, EC715RV. Manual part — 155

2.10.8 Removal and Installation
2.10.8.1

Camshaft

Position

Sensor

Replacement

Removal Procedure:

Warning!

Refer to "Battery Disconnection Warning" in "Warnings
and Notices".

FE02-0378b

1.

Disconnect the battery negative cable. Refer to

2.11.8.1

Battery Disconnection

.

2.

Disconnect the camshaft position sensor wiring harness
connector.

FE02-0379b

3.

Remove the sensor retaining bolts.

Engine

Ignition System JL4G18-D

2-535

FE02-0380b

4.

Remove the camshaft position sensor.

Installation Procedure:

FE02-0381b

1.

Check to confirm whether the camshaft position sensor
seals are intact.

FE02-0382b

2.

Install camshaft position sensor and tighten the retaining
bolt.

Torque: 9 Nm (Metric) 6.7 lb-ft (US English)

2-536

Ignition System JL4G18-D

Engine

FE02-0383b

3.

Connect the camshaft position sensor wiring harness
connector.

4.

Connect the battery negative cable.

2.10.8.2

Crankshaft

Position

Sensor

Replacement

Removal Procedure:

Warning!

Refer to "Battery Disconnection Warning" in "Warnings
and Notices".

FE02-0384b

1.

Disconnect the battery negative cable. Refer to

2.11.8.1

Battery Disconnection

.

2.

Remove the air filter.

Engine

Ignition System JL4G18-D

2-537

FE02-0385b

3.

Disconnect the crankshaft position sensor wiring harness
connector.

FE02-0386b

4.

Remove the sensor retaining bolts.

Note

After removing the sensor, plug the sensor mounting
hole to prevent debris falling into it.

Installation Procedure:

FE02-0387b

1.

Install the sensor and tighten the retaining bolts.

Torque: 9 Nm (Metric) 6.7 lb-ft (US English)

2.

Connect the crankshaft position sensor wiring harness
connector.

3.

Install the air filter assembly.

Torque: 9 Nm (Metric) 6.7 lb-ft (US English)

4.

Connect the battery negative cable.

2-538

Ignition System JL4G18-D

Engine