Geely EC718, EC718RV, EC715, EC715RV. Manual part — 358
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 358
9.2.7 Removal and Installation
9.2.7.1 Airbag Control Module Replacement
Removal Procedure
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
FE09-0001b
1.
Disconnect the battery negative cable. Refer to
.
Note
Start removal 90s after the battery negative is
disconnected.
2.
Remove the center console cup holder. Refer to
.
3.
Remove the rear air duct.
FE09-0002b
4.
Remove the airbag control module retaining bolts.
5.
Disconnect the airbag control module wire harness
connector and remove the airbag control module.
Safety Protection Device
Airbag System
9-31
Installation Procedure:
FE09-0002b
1.
Install the airbag control module retaining bolts.
Torque: 8 Nm (Metric) 5.9 lb-ft (US English)
2.
Connect the airbag control module wiring harness
connector.
FE09-0003b
3.
Install the rear air duct.
4.
Install the center console cup holder.
5.
Connect the battery negative cable.
9.2.7.2 Driver Front Airbag Replacement
Removal Procedure
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
9-32
Airbag System
Safety Protection Device
FE09-0005b
1.
Disconnect the battery negative cable. Refer to
.
Note
Start removal 90s after the battery negative is
disconnected.
2.
Remove the driver front airbag retaining screws on both
sides.
Warning!
Refer to "Supplement Protection System Warning" in
"Warnings and Notices".
FE09-0006b
3.
Disconnect the clock spring and the driver front airbag
wiring harness connector.
4.
Disconnect the horn wiring harness connector and
remove the driver front airbag.
Installation Procedure:
FE09-0007b
1.
Connect the horn harness connector and the clock spring
harness connector.
2.
Tighten the driver front airbag retaining screws. Before
tightening the retaining screws, preload the retaining
screws first.
Torque: 9 Nm (Metric) 6.6 lb-ft (US English)
3.
Connect the battery negative cable.
Safety Protection Device
Airbag System
9-33
9.2.7.3 Clock Spring Replacement
Removal Procedure
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
FE09-0008b
1.
Disconnect the battery negative cable and wait for the
90s. Refer to
.
2.
Adjust the steering wheel to a straight state and locked.
3.
Remove the driver front airbag. Refer to
4.
Remove the steering wheel. Refer to
5.
Remove the steering column upper and lower shield
panels.
Refer
to
FE09-0009b
6.
Disconnect the clock spring harness connector and
remove the clock spring.
9-34
Airbag System
Safety Protection Device
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст