Geely EC718, EC718RV, EC715, EC715RV. Manual part — 104
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 104
FE02-0012b
7.
Remove the cylinder head cover.
FE02-0013b
8.
Remove the cylinder head gasket from the cylinder head
cover.
Engine
Engine Mechanical System JL4G18-D
2-331
Installation Procedure:
FE02-0014b
1.
Install the cylinder head cover gasket.
FE02-0015b
2.
Apply sealant evenly in the cylinder head gasket.
3.
Install the cylinder head cover.
2-332
Engine Mechanical System JL4G18-D
Engine
FE02-0011b
4.
Tighten the cylinder head cover bolts.
Note
When tightening, tighten a single bolt several times,
in accordance with the specified torque.
Short Bolts:
Torque: 9 Nm (Metric) 6.7 lb-ft (US English)
Long Bolts, Nuts, Special Bolts:
Torque: 11 Nm (Metric) 8.2 lb-ft (US English)
FE02-0017b
5.
Install the crankcase ventilation vacuum tube.
FE02-0018b
6.
Install the crankcase ventilation tube.
7.
Install ignition coil and ignition wire.
8.
Install the engine plastic shield.
9.
Connect the battery negative cable.
2.6.8.3 Drive Belt Replacement
Removal Procedure:
Warning!
Refer to "Battery Disconnection Warning" in "Warnings
and Notices".
Engine
Engine Mechanical System JL4G18-D
2-333
FE01-0019b
1.
Disconnect the battery negative cable. Refer to
.
2.
Rotate the drive belt tensioner anti-clockwise with a
wrench to remove the drive belt.
Note
In the removal process, prevent the wrench slipping
causing injury to the operator.
Installation Procedure:
FE01-0020b
1.
Wrap the drive belt as shown.
FE01-0021b
2.
Rotate the drive belt tensioner clockwise with a wrench to
install the drive belt.
2-334
Engine Mechanical System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст