Geely EC718, EC718RV, EC715, EC715RV. Manual part — 142

7.

Slowly fill the engine coolant into the Coolant Recovery
Reservoir to the standard scale, so that the air will be
discharged from the cooling outlet pipe.

8.

Start the engine until the thermostat switches on. When
the radiator inlet and outlet pipes are hot, it can be
identified that the thermostat is switched on.

9.

Shut down the engine. Confirm that the engine coolant
drainage valve is not leaking. (Repeat the above steps
until the discharged coolant is free of bubble.)

10. Fill the engine coolant so that the engine coolant Coolant

Recovery Reservoir coolant level reaches the highest
scale (MAX location).

2.8.8.2

Coolant

Recovery

Reservoir

Replacement

Removal Procedure:

Warning!

Refer to "Warnings and Notices" in the "warning on
cooling system maintenance."

FE02-0321b

1.

Discharge the engine coolant.

2.

Remove the coolant recovery reservoir upper retaining
bolt.

Engine

Cooling System JL4G18-D

2-483

FE02-0322b

3.

Remove the engine coolant overflow pipe.

FE02-0323b

4.

Remove the coolant recovery reservoir lower retaining
bolt.

Installation Procedure:

FE02-0324b

1.

Install the coolant recovery reservoir upper retaining bolt.

Torque: 25 Nm (Metric) 18.5 lb-ft (US English)

2-484

Cooling System JL4G18-D

Engine

FE02-0325b

2.

Install the coolant recovery reservoir lower retaining bolt.

Torque: 25 Nm (Metric) 18.5 lb-ft (US English)

MAX

MIN

MIN

MAX

FE02-0326b

3.

Fill the engine coolant to the level between the MIN and
MAX.

FE02-0327b

4.

Install the coolant recovery reservoir cap and the engine
coolant overflow pipe.

2.8.8.3 Cooling Fan Replacement

Removal Procedure:

Warning!

Do not place hands in between fan blades running area
when the fan is not switched off.

Engine

Cooling System JL4G18-D

2-485

FE02-0328b

1.

Disconnect the battery negative cable. Refer to

2.11.8.1

Battery Disconnection

.

2.

Remove the radiator air baffle and deflector.

FE02-0329b

3.

Disconnect the fan motor wiring harness connector.

FE02-0330b

4.

Remove the right side of the fan cover retaining bolt.

2-486

Cooling System JL4G18-D

Engine