Geely EC718, EC718RV, EC715, EC715RV. Manual part — 521

FE12-0029b

14. Fold down the rear seat and remove the headliner via the

trunk.

Note

Due to the seal between the headliner and the roof,
pull the headliner out at an angle. Do not squeeze
or dissemble the headliner. The headliner removal
is the same for vehicles with or without sunroof.

Installation Procedure:

FE12-0030b

1.

Pull the rear seat to the upright position. Place the
headliner back into the vehicle via the trunk as per
removal.

2.

Place the headliner to the roof. Engage the headliner rear
retaining clips.

FE12-0031b

3.

Install the sunshade hook.

Torque: 5 Nm (Metric) 3.7 lb-ft (US English)

Body, Sheet Metal and Painting

Interior Trim

12-73

FE12-0032b

4.

Connect the left sunshade harness connector and run the
harness through the sunshade hook.

FE12-0033b

5.

Install and tighten the left sunshade retaining bolt. The
right sunshade installation is the same.

Torque: 5 Nm (Metric) 3.7 lb-ft (US English)

FE12-0034b

6.

Install the right front assist handle retaining screws. The
left rear and right rear assist handle installations are the
same.

Torque: 5 Nm (Metric) 3.7 lb-ft (US English)

7.

Install the door seal strips.

8.

Install the dome lamp.

9.

Install the windshield garnish molding, install the center
pillar upper trim panel and install the quarter upper trim
panel.

10. Install the front and rear door sill trim plate.

12-74

Interior Trim

Body, Sheet Metal and Painting

12.9.1.2 Left and Right Door Sill Nameplate
Replacement

Removal Procedure:

Note

To remove left/right door sill nameplate, please use
interior trim panel removal tools. Otherwise, it is easy to
scratch door sill nameplate.

FE12-0035b

1.

Disengage the front door sill trim plate retaining clips and
loose the front door sill trim plate.

FE12-0036b

2.

Remove the body hinge pillar trim retaining nut and clip
and remove the door sill nameplate.

Body, Sheet Metal and Painting

Interior Trim

12-75

FE12-0037b

3.

Disengage the rear door sill nameplate retaining clips and
loose the rear door sill nameplate.

FE12-0038b

4.

Lift the rear seat cushion, disengage the body lock pillar
trim retaining clips and remove the rear door sill trim plate.

Installation Procedure:

FE12-0039b

1.

Install the body lock pillar trim and install the rear seat
cushion.

2.

Press the rear door sill nameplate into position.

12-76

Interior Trim

Body, Sheet Metal and Painting