Geely EC718, EC718RV, EC715, EC715RV. Manual part — 507
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 507
FE12-0121b
3.
Pull the rear compartment lid torsion spring (Left) to the
right side to remove it.
FE12-0122b
4.
Remove the rear compartment lid torsion spring (Right),
similar to the rear compartment lid torsion spring (Left).
5.
Remove the rear compartment lid torsion spring bracket.
Installation Procedure:
Note
Install the rear compartment lid torsion spring (Right)
first, and then install the left side spring.
FE12-0123b
1.
Install the rear compartment lid torsion spring bracket.
Body, Sheet Metal and Painting
Body Rear End
12-17
FE12-0124b
2.
Install the top left end of the rear compartment lid torsion
spring (Right) into the mounting hole.
FE12-0125b
3.
Attach the rear compartment lid torsion spring (Right) to
the rear compartment lid torsion spring bracket.
FE12-0126b
4.
Install the top right end of the rear compartment lid torsion
spring (Right) into the mounting hole first, then install the
rear compartment lid torsion spring (Right) to the hinge
and the body.
5.
Install the rear compartment lid torsion spring (Left),
similar to the rear compartment lid torsion spring (Right).
12-18
Body Rear End
Body, Sheet Metal and Painting
12.3.3.3 Hatchback and Hatchback Hinge
Replacement (Hatchback)
Removal Procedure:
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
1
2
FE12-0127c
1.
Open and use a suitable brace to support the hatchback.
2.
Disconnect the battery negative cable. Refer to
.
3.
Remove the body lock pillar upper trim panel. Refer to
Rear Quarter Upper Trim Panel Replacement
.
4.
Remove wiring harness connector 1 and rear window
washer hose 2.
5.
Remove the hatchback trim panel. Refer to
Compartment Trim Panel Replacement
.
6.
Remove the hatchback strut. Refer to
FE12-0128c
7.
Remove the left and right hatchback to the hinges
retaining bolts.
8.
With the aid of an assistant, remove the hatchback.
Body, Sheet Metal and Painting
Body Rear End
12-19
FE12-0129c
9.
Remove the hatchback hinge retaining nuts, two on each
side.
10. Remove the hatchback hinges.
Installation Procedure:
FE12-0130c
1.
Install the hatchback hinge retaining nuts and tighten.
Torque: 25 Nm (Metric) 18.5 lb-ft (US English)
FE12-0131c
2.
Install the hatchback to the hinges and tighten the
retaining bolts.
Torque: 25 Nm (Metric) 18.5 lb-ft (US English)
3.
Route the hatchback wiring harness to rear compartment
and connect wiring harness connectors and rear window
washer hoses.
4.
Install the body lock pillar upper trim panel.
5.
Install the hatchback trim panel.
12-20
Body Rear End
Body, Sheet Metal and Painting
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст