Geely EC718, EC718RV, EC715, EC715RV. Manual part — 275
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 275
4.2.7.7 Lower Control Arm Ball Joint
Replacement
Removal Procedure:
1
2
FE04-0030b
1.
Lift and support the vehicle.
2.
Remove the front wheels. Refer to
3.
Remove the the ball joint opening pin (1) and the nut (2).
FE04-0031b
4.
Use a universal tool to separate the ball joint and the
steering knuckle.
Note
Only use a universal tool to separate the ball joint
and the steering knuckle. Do not use a hand
hammer or pry bar to remove the ball joint. If the
recommended tool is not used, it will lead to the ball
joint and seal damage.
FE04-0032b
5.
Remove the ball of retaining nuts and bolts.
6.
Remove the ball joint.
Suspension System
Front Suspension
4-29
Installation Procedure:
Note
Refer to "Fastener Notice" in "Warnings and Notices".
FE04-0033b
1.
Install the ball joint to the lower control arm and tighten the
bolts.
Torque: 145 Nm (Metric) 107.3 lb-ft (US English)
FE04-0034b
2.
Tighten the ball joint nuts.
Torque: 145 Nm (Metric) 107.3 lb-ft (US English)
2
1
FE04-0035b
3.
Install the ball inside to the steering knuckle and tighten
the slotted hex nut (1) and the opening pin (2).
Torque: 145 Nm (Metric) 107.3 lb-ft (US English)
4.
Install the front wheels.
5.
Lower the vehicle.
Note
Left and right front ball joint replacement is similar.
4-30
Front Suspension
Suspension System
4.2.7.8 Steering Knuckle Replacement
Removal Procedure:
4
3
2
1
FE04-0036b
1.
Lift and support the vehicle.
2.
Remove the front wheels. Refer to
3.
Remove the ball joint. Refer to
.
4.
Remove the steering tie rod to the steering knuckle
opening pin (1) and slotted hex nut (2). Separate the
steering tie rod.
5.
Remove the wheel speed sensor retaining bolt (3).
Remove the wheel speed sensor from the steering
knuckle.
6.
Remove the front wheel hub nut (4).
7.
Remove the steering knuckle to the shock absorber bolts.
Remove the steering knuckle from the shock absorber.
FE04-0037b
8.
Remove the steering knuckle with the front wheel hub.
Suspension System
Front Suspension
4-31
FE04-0038b
9.
Remove the front wheel hub retaining ring.
FE04-0039b
10. Use the special tool GL401-001 to remove the front wheel
hub from the steering knuckle.
Installation Procedure:
FE04-0040b
1.
Place a piece of wood under the front wheel hub and
install the front wheel hub to the steering knuckle.
Note
Refer to "Fastener Notice" in "Warnings and
Notices".
4-32
Front Suspension
Suspension System
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст