Geely EC718, EC718RV, EC715, EC715RV. Manual part — 110
Geely EC718, EC718RV, EC715, EC715RV. Manual part - 110
GL301-020
FE02-0144b
14. Use special tool GL301-020 to remove the crankshaft
pulley.
FE02-0145b
15. Remove the timing chain tensioner.
FE02-0146b
16. Remove the timing chain cover M8 tightening bolts.
Engine
Engine Mechanical System JL4G18-D
2-355
FE02-0147b
17. Remove the timing chain cover M6 tightening bolts and
nuts.
FE02-0148b
18. Pry groove position with a bar to loosen the timing chain
cover.
FEE02-0149b
19. Remove the timing chain cover.
2-356
Engine Mechanical System JL4G18-D
Engine
Installation Procedure:
FE02-0150b
1.
Clean the residual sealant on the timing chain cover and
cylinder.
FE02-0151b
2.
Apply special sealant on the timing chain cover and
cylinder block mounting surface evenly and install the
timing chain cover.
Note
Before installing the timing chain cover, pay
attention to check the timing chain marks made
above are consistent. If there is bias, please re-
install the timing chain. Refer to 2.6.8.10
FE02-0152b
3.
Install M6 timing chain cover tightening bolts and nuts, but
do not tighten at this stage.
Engine
Engine Mechanical System JL4G18-D
2-357
1
3
7
2
4
9
11
5
10
12
6
8
FE02-0153b
4.
Install M8 timing chain cover tightening bolts and tighten
timing chain cover tightening bolts and nuts, total of 12,
according to the sequence shown in the graphic.
M6 Bolts and Nuts:
Torque: 12 Nm (Metric) 8.2 lb-ft (US English)
M8 Bolt:
Torque: 18 Nm (Metric) 13.4 lb-ft (US English)
FE02-0154b
5.
Install the timing chain tensioner. Refer to
FE02-0155b
6.
Install the crankshaft belt sprocket.
2-358
Engine Mechanical System JL4G18-D
Engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст