Scania Central gear RP832-RBP832. Manual — part 7
08:04-02
©
25
13 Tighten the end yoke nut with sleeve
98 765. Tightening torque 400 Nm.
88 292
99 129
98 765
111 495
400 Nm
14 Stake the nut flange in two places towards
the recesses in the end yoke to lock the nut.
IMPORTANT! Turn around the differential
lock cover. Make sure the diaphragm is in place.
Spot repairs
26
©
08:04-02
Overhaul
Central gear
Special tools
Number
Description
Illustration
Board
98 401
V block
98 402
Retainer for fixture shaft
98 403
Fixture shaft
98 404
End yoke bracket
98 405
Bracket and fixture beam
98 776
Mounting fixture
99 167
Lifting tool
G1
587 313
Gearbox jack
00
1899
98 401
00_1643
98 402
00
1644
98 403
98 404
00_1645
98 405
00
1646
98 776
110 877
00
1625
99 167
102 902
Central gear
08:04-02
©
27
Removal
1
If the vehicle is loaded, relieve the rear axle
housing before removing the gear.
2
Lift the vehicle and support the rear axle on
stands under the springs. Remove the
wheels.
3
Drain the oil from the rear axle housing.
4
Turn the hub so that plug 3 is at the bottom.
100910
1
2
3
1
Marker line
2
Filler plug
3
Drain plug
!
WARNING!
The vent in the hub cover may be
blocked. Use protective goggles as oil
can spurt out at high pressure when the
oil plug is removed.
5
Remove plugs 2 and 3 and drain the oil.
6
Remove retaining ring 31 and thrust washer
30. Screw in an M10 bolt into the end of the
drive shaft and pull out the drive shaft
carefully, taking care not to damage the
sealing rings 40 in the axle tube.
7
Loosen the bracket for the compressed air
pipes.
8
Remove the pipe to the differential locks.
9
Remove the brake chambers.
32
31 30
20
27
104
717
Central gear
28
©
08:04-02
IMPORTANT! Remove the cover for the bogie
differential lock on the RBP832 and refit it the
other way round so that the differential lock
engages.
Bogie differential lock RBP832
10 Detach the cables to the switch for the
differential lock(s).
11 Remove both propeller shafts from the axle
gear end yoke.
12 Remove the four bottom nuts securing the
gear to the rear axle housing.
13 Rig the gearbox jack with 98 401, 98 402,
98 403, 98 404 and 98 405.
14 Attach the axle gear to the jack.
RBP832
RP832
15 Remove the remaining nuts securing the
gear and pull it forwards from the rear axle
housing.
Central gear
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст