Scania 16 litre engine. Work Description — part 35
4
ã
Scania CV AB 2001, Sweden
01:06-02
Removal
IMPORTANT! While carrying out the work, cover all holes for e.g. turbocharger and fluid filler to
prevent bolts and other parts from entering the engine. Contaminants entering the engine can cause
severe engine damage.
Remove
Remarks
Item no
1
Cab
See 18:01-01.
2
Oil and coolant
3
Mudguards
4
Catwalks
5
Negative cable from battery
6
Control cable between thermostat and
electric fan
Detach the housing and place it to one
side. Applies only to vehicles with
electric fan.
6
7
Noise shields under the engine
8
Coolant lines
Upper and lower
8
9
Charge air pipes
9
10
Bleed line from engine to expansion
tank
10
11
Inlet pipe between turbocharger and air
filter
To secure 587 308.
11
12
Front air cleaner pipe and air cleaner
12
13
Bracket
13
14
Wiring
Mark to facilitate fitting.
14
15
Cable duct to engine speed sensor on
the flywheel
15
16
Exhaust brake and exhaust bellows
after the turbocharger
16
17
Cable to speed sensor
17
18
Air hose to exhaust brake
18
19
Oil pipes from gearbox oil cooler
Applies only to vehicles with fluid
cooled gearbox oil cooler.
19
20
Earth braids on the right and left-hand
sides
Removal
01:06-02
ã
5
Removal
6
ã
Scania CV AB 2001, Sweden
01:06-02
IMPORTANT! The lifting eyes on the engine are not dimensioned to lift the whole vehicle and
therefore must not be used for this purpose. When lifting the engine, all three lifting eyes must always
be used.
IMPORTANT! The lifting eyes are dimensioned for a maximum lifting angle of 20° when lifting the
engine.
Remove
Remarks
Item no
21 Compressed air line
21
22 Signal lead from compressor
22
23 Fuel lines
Mark the lines to facilitate fitting.
23
24 AC compressor
Fold away without detaching hoses.
24
25 Power steering pump
Fold away without detaching hoses.
25
26 Filter housing to crankcase ventilation
Fold away so that it is free from the
lifting chain.
26
27 Fluid filler and oil dipstick
Plug the holes to prevent contaminants
entering the engine.
27
28 Drain pipe for crankcase ventilation
28
Fit
Remarks
Item no
29 Lifting eyes 99 398
One lifting eye at the rear of each
cylinder line. Use flange bolts M12x30
and torque tighten to 92 Nm. The bolt
holes are plugged. Fold away the drain
pipe to fit the right-hand lifting eye, fold
away the fuel pressure test connection to
fit the left-hand lifting eye.
29
30 Lifting chain 99 094 to rear lifting eyes.
30
31 Lever block 587 308 to front lifting eye. The engine lifting angle can be adjusted
with the lever block.
31
Remove
Remarks
Item no
32 Gearbox
See 05:00-01.
33 The two front engine brackets
34 Engine
Removal
01:06-02
ã
7
Removal
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст