Scania 16 litre engine. Work Description — part 29

0120w13b.mkr

©

113

1

Unscrew the nut securing the outer lid.

2

Lift out the rotor. Wipe off the outside.
Undo the rotor nut and screw it about three
turns to protect the bearing.

0

11

2

86

x3

3

If the rotor nut is difficult to get loose, turn
the rotor upside down and fasten the rotor
nut in a vice. Turn the rotor
counterclockwise three turns by hand or if
this does not help, place a screwdriver
between the outlet holes.

x3

0

11

2

8

7

Oil cleaner

IMPORTANT! The rotor must not be put in a
vice. Never strike the rotor bowl. This may
cause damage resulting in imbalance.

114

©

0120w13b.mkr

7

Scrape away the deposits inside the bowl
with a knife.

8

Wash the parts.

9

Inspect the two nozzles on the rotor. Make
sure they are not blocked or damaged.
Renew damaged nozzles.

10 Make sure the bearings are not damaged.

Oil cleaner

4

Grasp the rotor bowl and tap lightly with
your hand or a plastic mallet on the rotor nut
so that the rotor bowl comes loose from the
rotor. Never strike on the rotor directly as
this may damage its bearings.

5

Remove the rotor nut and bowl from the
rotor.

6

Remove the strainer located on the rotor. If
the strainer has fastened, prise carefully
with a knife at the bottom between the rotor
and the strainer.

01

1289

0120w13b.mkr

©

115

Assembly

Specifications

1

Put the O-ring in place in the lid. Renew the
O-ring if it is at all damaged.

2

Assemble the parts and tighten the rotor nut
by hand.

Tightening torques

Lock nut for oil cleaner housing lid

15 Nm

Nut for rotor bowl

Tighten by hand

Rotor shaft

34 Nm

Thread locking compound

561 200

01

1293

3

Make sure the shaft is not loose. Secure with
locking compound 561 200 if it is loose.
Clean thoroughly first with a suitable
solvent. Tighten the rotor shaft using socket
98 421. Tightening torque 34 Nm

4

Refit the rotor and spin it by hand to make
sure it rotates easily.

Oil cleaner

112

3

1

3

5

Inspect the O-ring on the cleaner housing lid
and fit it. Torque tighten the lock nut to
15 Nm.

112

314

15 Nm

116

©

0120w13b.mkr

Oil pump

A leaking or defective oil pump must be
renewed completely and not overhauled.

Renewing the oil pump

Tightening torques

Special tools

Plug for oil sump

80 Nm

Bolts for exhaust manifold

63 Nm

Bolts for oil sump

32 Nm

Designation Number

Illustration

Tool board

Engine
support

99 318

Lifting eyes

99 398

99 398

114 638

112 315

1

2

3

1

Strainer

2

Suction pipe

3

Oil pump

Oil pump