Scania 16 litre engine. Work Description — part 30
0120w13b.mkr
©
117
Removing
1
Drain the engine oil from the oil sump.
Clean the magnetic plug and torque tighten
to 80 Nm.
2
Remove the oil sump.
3
Remove the gearbox (refer to group 5).
Support the engine using tool 99 318.
Remove the clutch.
4
Remove the flywheel as described in
Flywheel, removing.
5
Remove the rear exhaust manifold.
6
Remove the flywheel housing as described
in Flywheel housing, removing.
7
Remove the strainer and the suction pipe.
8
Remove the oil pump.
Oil pump
118
©
0120w13b.mkr
Fitting
1
Renew the O-ring and fit a new oil pump.
2
Renew the O-rings and refit the strainer and
suction pipe.
3
Fit the flywheel housing as described in
Flywheel housing, fitting.
4
Refit the air compressor and exhaust
manifold. Torque tighten the exhaust
manifold to 63 Nm.
5
Fit the flywheel as described in Flywheel,
fitting.
6
Refit the clutch and gearbox.
7
Fit the oil sump and torque tighten the bolts
to 32 Nm.
8
Fill with oil and check the oil level in the
engine using the dipstick.
Oil pump
0125w13b.mkr
©
119
Exhaust manifold
Renewing gaskets
Tightening torque
1
Undo the bolts and remove the front exhaust
manifold.
2
Undo the bolts and remove the rear exhaust
manifold.
3
Scrape away the gaskets from the exhaust
manifolds and cylinder head.
4
Lubricate the joints with heat-resistant
grease and fit new gaskets.
5
Fit the rear exhaust manifold and junction
pipe.
6
Fit the front exhaust manifold.
7
Torque tighten all bolts to 63 Nm.
Bolts for exhaust manifold
63 Nm
Exhaust manifold
©
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст