Lexus GS300/400 (2000 year). Manual — part 13
AC22C–01
I10090
10 mm (0.39 in.)
Hexagon
Wrench
Modulator
I10092
I10093
2 Layered
Part
I10091
Protrusion
I10094
–
AIR CONDITIONING
CONDENSER
AC–49
2734
REPLACEMENT
REPLACE DRYER FROM MODULATOR
(a)
Using a hexagon wrench (10 mm, 0.39 in.), remove the
cap from the modulator.
(b)
Remove the filter from the modulator.
(c)
Using pliers, remove the dryer.
(d)
Insert a new dryer into the modulator.
NOTICE:
Do not remove the dryer from a vinyl bag until insert-
ing it into the modulator.
Install the dryer with its 2 layered part faced upward
to the modulator.
(e)
Insert the filter into the modulator.
NOTICE:
Install the filter with its protrusion faced downward to the
modulator.
(f)
Install the cap to the modulator.
(1)
Apply compressor oil to the o–rings and screw part
of the cap.
Compressor oil: ND–OIL 8 or equivalent
(2)
Using a hexagon wrench (10 mm, 0.39 in.), install
the caps.
Torque: 12.3 N·m (125 kgf·cm, 9 ft·lbf)
AC0X1–01
AC–50
–
AIR CONDITIONING
CONDENSER
2735
INSTALLATION
Installation is in the reverse order of removal (See page
AC0X2–01
I02400
I02401
SST
–
AIR CONDITIONING
EVAPORATOR
AC–51
2736
EVAPORATOR
REMOVAL
1.
REMOVE A/C UNIT
(See page
2.
REMOVE HEATER RADIATOR
(See page
3.
REMOVE AIR MIX SERVOMOTOR PASSENGER SIDE
(a)
Disconnect the connector.
(b)
Remove the 3 screws and servomotor.
4.
REMOVE TUBE AND ACCESSORY
(a)
Pry out packing.
HINT:
At the time of installation, please refer to the following item.
Do not reuse the packing.
(b)
Using SST, remove the 2 bolts and the tube and accesso-
ry.
SST
07110–61050
Torque: 4.1 N·m (42 kgf·cm, 36 in.·lbf)
NOTICE:
Cap the open fittings immediately to keep moisture or dirt
out of the system.
HINT:
At the time of installation, please refer to the following item.
Lubricate 2 new O–rings with compressor oil and install them
to the tube.
(c)
Remove screw and drain pipe.
I02402
AC–52
–
AIR CONDITIONING
EVAPORATOR
2737
5.
REMOVE EVAPORATOR
(a)
Disconnect the connector from blower motor control
relay.
(b)
Remove the screw and drain hose.
(c)
Remove the 4 screws and cover.
(d)
Pull out the evaporator.
HINT:
At the time of installation, please refer to the following item.
If evaporator is replaced, add compressor oil to evaporator.
Add 40 cc (1.4 fl. oz.)
Compressor oil: ND–OIL 8 or equivalent
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст