Lexus GS300/400 (2000 year). Manual — part 256
SA0SZ–01
SA–104
–
SUSPENSION AND AXLE
TOE CONTROL LINK
2104
INSTALLATION
Installation is in the reverse order of removal (See page
).
AFTER INSTALLATION, CHECK REAR WHEEL ALIGNMENT (See page
SA0T0–01
F01993
Stabilizer Bar
Bushing
Bracket
Stabilizer Bar Link
N·m (kgf·cm, ft·lbf) : Specified torque
65 (660, 48)
18 (185, 13)
30 (305, 22)
–
SUSPENSION AND AXLE
REAR STABILIZER BAR
SA–105
2105
REAR STABILIZER BAR
COMPONENTS
SA0R7–05
R05806
R11093
SST
R11078
SST
SA–12
–
SUSPENSION AND AXLE
FRONT AXLE HUB
2012
DISASSEMBLY
1.
REMOVE FRONT HUB GREASE CAP
Using a screwdriver, remove the grease cap from the steering
knuckle.
2.
REMOVE FRONT AXLE HUB LOCK NUT AND ABS
SPEED SENSOR ROTOR
(a)
Clamp the axle hub in a soft jaw vise.
HINT:
Close vise until it holds hub bolt. Do not tighten further.
(b)
Using a chisel and hammer, loosen the staked part of the
lock nut.
(c)
Using a 36 mm socket wrench, remove the lock nut.
(d)
Remove the ABS speed sensor rotor.
NOTICE:
Take care not to scratch the serrations of the sensor rotor.
3.
REMOVE AXLE HUB FROM STEERING KNUCKLE
(a)
Remove the 4 bolts and shift the brake dust cover toward
the outside.
(b)
Using SST, remove the axle hub from the steering
knuckle.
SST
09950–40011 (09951–04020, 09952–04010,
09953–04020, 09954–04010, 09955–04051,
09957–04010, 09958–04011)
4.
REMOVE INNER RACE (OUTSIDE) FROM AXLE HUB
Using SST, remove the inner race from the axle hub.
SST
09950–40011 (09951–04020, 09952–04010,
09953–04020, 09954–04010, 09955–04061,
09957–04010, 09958–04011)
R06209
SST
W00273
SST
–
SUSPENSION AND AXLE
FRONT AXLE HUB
SA–13
2013
5.
REMOVE OIL SEAL
Using SST, remove the oil seal from the steering knuckle.
SST
09308–00010
6.
REMOVE BEARING FROM STEERING KNUCKLE
(a)
Using snap ring pliers, remove the snap ring.
(b)
Using SST and a press, remove the bearing from the
steering knuckle.
SST
09950–60010 (09951–00560)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст