Lexus RX300 (MCU15). Manual — part 569
D03802
D03587
D03791
D03908
D03588
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
AX–19
U140F AX (RM848E)
(b)
Remove the bearing race from the direct clutch.
34.
REMOVE REAR PLANETARY SUN GEAR ASSEMBLY
(a)
Remove the rear planetary sun gear assembly from the
transaxle case.
(b)
Remove the thrust bearing from the rear planetary sun
gear.
(c)
Remove the thrust washer No.1 from the rear planetary
sun gear.
35.
REMOVE ONE–WAY CLUTCH NO.1
(a)
Remove the one–way clutch No.1 and thrust bearing from
the transaxle case.
D03909
D03589
D03590
D03616
D03592
AX–20
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
U140F AX (RM848E)
(b)
Remove the inner race from the one–way clutch No.1.
36.
REMOVE ONE–WAY CLUTCH OUTER SLEEVE
37.
REMOVE 2ND BRAKE
(a)
Using a screwdriver, remove the snap ring.
(b)
Remove the flange, 4 discs and 4 plates from the trans-
axle case.
38.
REMOVE REAR PLANETARY GEAR
(a)
Using a screwdriver, remove the snap ring.
(b)
Remove the rear planetary gear from the transaxle case.
D03910
D03593
D03873
D03595
D03596
SST
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
AX–21
U140F AX (RM848E)
(c)
Remove the thrust washer No.2 from the rear planetary
gear.
(d)
Remove the bearing race from the rear planetary gear.
39.
REMOVE FRONT PLANETARY SUN GEAR
(a)
Remove the 2 thrust bearings, bearing race and front
planetary sun gear from the transaxle case.
40.
REMOVE FRONT PLANETARY GEAR ASSEMBLY
AND BRAKE HUB
(a)
Using a chisel and hammer, unstake the lock washer.
NOTICE:
Push down all claws of the washer. Otherwise SST can not
be fully pressed again the nut and can not loosen the nut.
(b)
Using SST, remove the nut.
SST
09387–00030, 09387–00080
D03597
SST
D03598
D03911
D03615
D03599
AX–22
–
AUTOMATIC TRANSAXLE
COMPONENT PARTS
U140F AX (RM848E)
(c)
Using SST and a press, remove the front planetary gear
assembly from the counter drive gear.
SST
09950–60010 (09951–00450)
41.
REMOVE 2ND BRAKE ASSEMBLY AND FRONT
PLANETARY RING GEAR
(a)
Using a screwdriver, remove the snap ring and brake hub
with 2nd brake cylinder assembly.
(b)
Remove the brake hub from the 2nd brake cylinder as-
sembly.
42.
REMOVE FRONT PLANETARY RING GEAR
Using a screwdriver, remove the snap ring and front planetary
ring gear from the brake hub.
43.
REMOVE 1ST & REVERSE BRAKE
(a)
Remove the flange, 7 discs and 7 plates from the trans-
axle case.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст