Lexus RX300 (MCU15). Manual — part 7
INTRODUCTION –
Vehicle Lift and Support Locations
IN-21
4WD
JACK POSITION
SUPPORT POSITION
PANTOGRAPH JACK POSITION
CAUTION: Before jacking–up the front and rear, make
sure the car is not carrying any extra weight.
Safety stand and swing arm type lift
Front frame
Rear differential support
Front
Rear
FRONT
INTRODUCTION
– Vehicle Lift and Support Locations
IN-22
PLATE TYPE LIFT
HINT:
Left and right set position
Front and rear set position
Place the over center of lift.
S Align the cushion gum ends of the plate with the attachment lower
ends (A).
S Align the attachment upper end (B) with the front cut–out at the
pantograph jack position.
S Place the rear attachment sideways.
Attachment
85 mm (3.35 in.)
70 mm (2.76 in.)
200 mm (7.87 in.)
100 mm (3.94 in.)
AR
AR-1
ANTI-RUST TREATMENT
Page
GENERAL INFORMATION
AR-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
BODY PANEL SEALING AREAS
AR-4
. . . . . . . . . . . . . . . . . . . . . . .
BODY PANEL UNDERCOATING AREAS
AR-9
. . . . . . . . . . . . . . . .
BODY PANEL ANTI-RUST AGENT
APPLICATION AREAS
AR-10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BODY PANEL ANTI-CHIPPING PAINT
APPLICATION AREAS
AR-11
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNDERCOAT APPLICATION
Weld-Through Primer
(Spot Sealer)
WELD-THROUGH PRIMER (SPOT SEALER)
APPLICATION
Sealer Gun
BODY SEALER APPLICATION
ANTI-RUST TREATMENT –
General Information
AR-2
GENERAL INFORMATION
Anti-rust treatment is necessary before welding and before and after the painting process.
ANTI-RUST TREATMENT BEFORE WELDING
1.
WELD-THROUGH PRIMER (SPOT SEALER)APPLICATION
For anti-corrosion measures, always apply the
weld-through primer (spot sealer) to welding sur-
faces where the paint film has been removed.
HINT:
Apply the weld-through primer (spot sealer)
so that it does not ooze out from the joining sur-
faces.
ANTI-RUST TREATMENT BEFORE PAINTING PROCESS
1.
BODY SEALER APPLICATION
For water-proofing and anti-corrosion measures, al-
ways apply the body sealer to the body panel seams
and hems of the doors, hoods, etc.
2.
UNDERCOAT APPLICATION
To prevent corrosion and protect the body from
damage by flying stones, always apply sufficient
undercoat to the bottom surface of the under body
and inside of the wheel housings.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст