Lexus RX300 (MCU15). Manual — part 514
SR0MR–02
R11353
Matchmarks
F04641
A
B
Matchmarks
F04640
SR–18
–
STEERING
TILT STEERING COLUMN
LEXUS RX300 (RM785E)
INSTALLATION
1.
INSTALL UNIVERSAL JOINT ASSEMBLY
(a)
Align the matchmarks on the universal joint and main
shaft.
(b)
Install the universal joint with the bolt.
Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
2.
INSTALL NO. 2 COLUMN HOLE COVER SUB–AS-
SEMBLY
(a)
Temporarily install the hose clamp to the No. 2 column
hole cover sub–assembly.
(b)
Install the No. 2 column hole cover sub–assembly to the
intermediate shaft sub–assembly.
3.
INSTALL INTERMEDIATE SHAFT SUB–ASSEMBLY
WITH NO. 2 COLUMN HOLE COVER SUB–ASSEMBLY
Temporarily install the intermediate shaft sub–assembly with
No. 2 column hole cover with the bolt ”A”.
4.
INSTALL STEERING COLUMN ASSEMBLY
(a)
Install the steering column assembly with the 4 column
assembly set nuts.
Torque: 26 N·m (260 kgf·cm, 19 ft·lbf)
(b)
Connect the connector.
5.
INSTALL LOWER INSTRUMENT FINISH PLATE
6.
CONNECT INTERMEDIATE SHAFT SUB–ASSEMBLY
(a)
Align the matchmarks on the intermediate shaft sub–as-
sembly and control valve shaft.
(b)
Install the intermediate shaft sub–assembly with the bolt
”B” and torque the bolt ”A”.
Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
(c)
Tighten the hose clamp.
7.
INSTALL SPIRAL CABLE (See page BE–29)
8.
INSTALL COMBINATION SWITCH WITH SPIRAL
CABLE
(a)
Install the combination switch with spiral cable with the 3
screws.
(b)
Connect the airbag connector.
(c)
Connect the 3 connectors.
W02655
Marks
F04639
Torx Screw
Screw Case
–
STEERING
TILT STEERING COLUMN
SR–19
LEXUS RX300 (RM785E)
9.
INSTALL COLUMN UPPER AND LOWER COVERS
Install the column upper and lower covers with the 3 screws.
10.
INSTALL LOWER LH INSTRUMENT PANEL INSERT
Install the lower LH instrument panel insert with the 2 bolts.
11.
INSTALL LOWER INSTRUMENT FINISH PANEL
(a)
Connect the hood lock control cable.
(b)
Connect the connector.
(c)
Install the lower instrument finish panel with the 2 bolts.
12.
CENTER SPIRAL CABLE
(a)
Check that the front wheels are facing straight ahead.
(b)
Turn the spiral cable counterclockwise by hand until it be-
comes harder to turn.
(c)
Then rotate the spiral cable clockwise about 2.5 turns to
align the marks.
HINT:
The spiral cable will rotate about 2.5 turns to either left or right
of the center.
13.
INSTALL STEERING WHEEL
(a)
Align the matchmarks on the steering wheel and main
shaft.
(b)
Install the steering wheel with the nut.
Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
(c)
Connect the connector.
14.
INSTALL STEERING WHEEL PAD
NOTICE:
S
Never use airbag parts from another vehicle. When
replacing parts, replace with new ones.
S
Make sure the wheel pad is installed to the specified
torque.
S
If the wheel pad has been dropped, or there are
cracks, dents or other defects in the case or connec-
tor, replace the wheel pad with a new one.
S
When installing the wheel pad, take care that the wir-
ings do not interfere with other parts and are not
pinched between other parts.
(a)
Connect the airbag connector.
(b)
Install the steering wheel pad after confirming that the cir-
cumference groove of the torx screws is caught on the
screw case.
(c)
Using a torx socket wrench, torque the 2 screws.
Torque: 8.8 N·m (90 kgf·cm, 78 in.·lbf)
(d)
Install the steering wheel lower No. 2 and No. 3 covers.
15.
CHECK STEERING WHEEL CENTER POINT
SR05Y–06
F04642
N·m (kgf·cm, ft·lbf) : Specified torque
z
Non–reusable part
* For use with SST
PS Vane Pump Assembly
z
Gasket
Union Bolt
Drive Belt
Oil Pressure Switch
Connector
43 (440, 32)
*29 (300, 21)
21 (210, 15)
52 (530, 38)
43 (440, 32)
Return Hose
Clip
Pressure Feed Tube
SR–20
–
STEERING
POWER STEERING VANE PUMP
LEXUS RX300 (RM785E)
POWER STEERING VANE PUMP
COMPONENTS
F04643
Pressure Port Union
z
O–ring
Flow Control Valve
Suction Port Union
Spring
z
Gasket
Rear Housing
Rear Bracket
Front Housing
Front Bracket
Vane Pump Rotor
z
O–ring
z
O–ring
z
Snap Ring
Vane Plate
Cam Ring
Wave Washer
Vane Pump Shaft
Vane Pump Pulley
Side Plate
N·m (kgf·cm, ft·lbf) : Specified torque
Power steering fluid
z
Non–reusable part
z
Oil Seal
z
Straight Pin
x10
83 (850, 62)
13 (130, 9)
43 (440, 32)
43 (440, 32)
43 (440, 32)
24 (240, 17)
24 (240, 17)
24 (240, 17)
z
–
STEERING
POWER STEERING VANE PUMP
SR–21
LEXUS RX300 (RM785E)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст