Lexus LS400 (2000 year). Manual — part 29
BE0CR–01
I03408
Electro Chromic Inner Mirror
Instrument Panel
Junction Block
ECU–IG Fuse
Ignition Switch
–
BE–193
2056
ELECTRO CHROMIC MIRROR SYSTEM
LOCATION
BE0CS–01
N16074
Z14965
Wire Harness Side
BE–194
–
BODY ELECTRICAL
ELECTRO CHROMIC MIRROR SYSTEM
2057
INSPECTION
1.
INSPECT ELECTRO CHROMIC INNER MIRROR OP-
ERATION
(a)
Connect the positive (+) lead from the battery to terminal
1 and the negative (–) lead to terminal 4.
(b)
Connect the positive (+) leaf from the voltmeter to terminal
2 and the negative (–) lead to terminal 3.
(c)
Shine an electric light on the mirror, and check that there
is battery positive voltage and mirror surface becomes
”bright” to ”dark”.
If operation is not as specified, replace the inner mirror.
2.
INSPECT ELECTRO CHROMIC INNER MIRROR CIR-
CUIT
Disconnect the connector from the mirror and inspect the con-
nector on the wire harness side, as shown.
If circuit is not as specified, inspect the circuits connected to oth-
er parts.
Tester connection
Condition
Specified condition
4 – Ground
Constant
Continuity
1 – Ground
Ignition switch LOCK or ACC
No voltage
1 – Ground
Ignition switch ON
Battery positive voltage
N17035
”Bright”
”Dark”
w/o Memory
I04603
”Bright”
”Dark”
w/ Memory
4
3
–
BODY ELECTRICAL
ELECTRO CHROMIC MIRROR SYSTEM
BE–195
2058
3.
INSPECT ELECTRO CHROMIC OUTER MIRROR OP-
ERATION
w/o Driving position memory:
(a)
Disconnect the outer mirror connector.
(b)
Connect the positive (+) lead from the dry through battery
to terminal 2 and the negative (–) lead to terminal 1, then
check that the mirror surface become ”dark”.
(c)
Reconnect to the dry through battery by the reverse order,
then check that the mirror surface become ”bright”.
If operation is not as specified, replace the mirror assembly.
4.
INSPECT ELECTRO CHROMIC OUTER MIRROR OP-
ERATION
w/ Driving position memory:
(a)
Disconnect the outer mirror connector.
(b)
Connect the positive (+) lead from the dry through battery
to terminal 4 and the negative (–) lead to terminal 3, then
check that the mirror surface become ”dark”.
(c)
Reconnect to the dry through battery by the reverse order,
then check that the mirror surface become ”bright”.
If operation is not as specified, replace the mirror assembly.
BE0CT–01
I03404
Seat Heater
(Seat Cushion)
Seat Heater
(Seat Back)
Seat Heater Switch
Engine Room Junction Block
FR S/HTR Fuse
Engine Main Relay
BE–196
–
2059
SEAT HEATER SYSTEM
LOCATION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст