Lexus LS400 (2000 year). Manual — part 43
BE0D5–01
I03241
I03242
I03244
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–241
2104
INSPECTION
1.
INSPECT GARAGE DOOR OPENER
Press the switch and check that each LED (red) lights up.
Even if only one switch is found not to light up, replace it.
2.
INSPECT GARAGE DOOR OPENER REGISTRATION
AND TRANSMITTING
HINT:
Use the home link tester made by KENT MORE for this test.
As it is necessary to record the code of the hand held transmit-
ter, customer’s code will be erased. When the inspection com-
pletes, please register the customer’s again.
(a)
Check that the code of hand held transmitter for inspec-
tion can be recorded.
(See page
If the code can not be registered, replace garage door opener.
(b)
Press the switch which an inspection code has been reg-
istered for and check that LED (green) of the home link
tester lights up.
If the LED (green) does not light up, replace the garage door
opener.
I03432
Wire Harness Side
BE–242
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
2105
3.
INSPECT GARAGE DOOR OPENER CIRCUIT
Disconnect the connector from the switch and inspect the con-
nector on the wire harness side, as shown.
Tester connection
Condition
Specified condition
5 – Ground
Constant
Continuity
4 – Ground
Constant
Battery positive voltage
BE0D6–01
–
BE–243
2106
INSTALLATION
1.
INSTALL GARAGE DOOR OPENER
(a)
Connect the wire harness to the terminal 4 and 5.
(b)
Install the 3 screws.
2.
INSTALL FRONT PERSONAL LIGHT
(a)
Connect the 2 connectors.
(b)
Install the 3 screws.
3.
INSTALL FRONT PERSONAL LIGHT LENS
BE0D7–01
START
Insert the key in the key cylinder.
Under registration
Registration completion
Remove the key.
Will you register the
next key?
No
Security indicator blinks until the first
key is inserted. The indicator lights up
after the key registration.
Security Indicator ON
Security Indicator
OFF
END
Yes
Security Indicator ON
(After the last key (sub–key)
has been registered, the indi-
cator goes off.)
BE–244
–
BODY ELECTRICAL
ENGINE IMMOBILISER SYSTEM
2107
ENGINE IMMOBILISER SYSTEM
REGISTRATION PROCEDURE
1.
KEY REGISTRATION IN AUTOMATIC REGISTRATION MODE
(a)
Registration of a new transponder key.
HINT:
This must be done when you install a new ECM.
The new ECM is on the automatic key code registration mode. The already fixed number of key codes
for this ECM can be registered.
On this type of vehicle, up to 4 key codes can be registered.
In the automatic registration mode, the last key registered becomes sub–key.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст