Lexus LS400 (2000 year). Manual — part 42

I03487

GARAGE DOOR
OPENER SWITCH

LEARN MODE

LED
OPERATION

ORIGINAL
TRANSMITTER

PRESSED

ENTER

EXIT

ON

OFF

20 sec

LED flashes
at a rate of 1 Hz

LED flashes at a
rate of 5.6 Hz

RELEASE

ON

OFF

–

BODY ELECTRICAL

GARAGE DOOR OPENER SYSTEM

BE–237

2100

New code registration timing chart

If a code can not be registered, observe the following condi-
tions.
HINT:

If the battery of original transmitter is consumed.

Press the switch of the transmitter repeatedly in registra-
tion mode, as some transmitters stop transmitting for 1 to
2 seconds.

This system is not applicable to the garage door opener
which had been made before 1982.

2.

CODE DELETION

(a)

Press the switches at both ends of garage door opener
simultaneously for 20 seconds.

HINT:
When transferring to deletion mode, LED (red) blinks in 6 Hz
cycle.
(b)

When releasing the switch within 10 seconds after trans-
ferring to deletion mode, all the registered codes will be
erased.

HINT:
Press the switch until blinking in 6 Hz cycle stops, so that the
default code for check is set.

I03488

LED
OPERATION

GARAGE DOOR
OPENER SWITCH
(Switch at both end)

ON

OFF

CLEAR/DEFAULT
MODE

PRESSED

LOAD DEFAULT

LED flashes at a rate of 6 HZ

10 SEC

20 SEC

RELEASE

ON

OFF

Enter erase mode to erase all 3 channels

BE–238

–

BODY ELECTRICAL

GARAGE DOOR OPENER SYSTEM

2101

Code deletion timing chart

BE0D3–01

I03403

Garage Door Opener

–

BE–239

2102

LOCATION

BE0D4–01

I03419

BE–240

–

2103

REMOVAL

1.

REMOVE FRONT PERSONAL LIGHT LENS

2.

REMOVE FRONT PERSONAL LIGHT

(a)

Remove the 3 screws.

(b)

Disconnect the 2 connectors.

3.

REMOVE GARAGE DOOR OPENER

(a)

Remove the 3 screws.

(b)

Remove the garage door opener connector from the per-
sonal light.

(c)

Disconnect the secondary locking device.

(d)

Release the locking plug of the terminal 4 and 5, and pull
the terminals out from the rear.

HINT:
Use a small screw driver.