Lexus ES300 (1997 year). Manual — part 349
D00048
–
DIAGNOSTICS
AUTOMATIC TRANSAXLE
DI–173
325
1997 LEXUS ES300 (RM511U)
3
Check shift solenoid valve No.1 or No.2.
PREPARATION:
(a)
Jack up the vehicle.
(b)
Remove the oil pan.
(c)
Disconnect the solenoid connector.
(d)
Remove the shift solenoid valve No.1 or No.2.
CHECK:
(a)
Measure resistance between solenoid connector and
body ground.
(b)
Connect the positive
lead to terminal of solenoid con-
nector, negative
lead to solenoid body.
OK:
(a) Resistance: 11
∼
15
Ω
(b) The solenoid makes an operating noise.
NG
Replace the solenoid valve.
OK
Repair or replace the solenoid wire.
Q04874
Controlled
Pressure
Line
Pressure
Drain
Controlled
Pressure
Q08040
DI–174
–
DIAGNOSTICS
AUTOMATIC TRANSAXLE
326
1997 LEXUS ES300 (RM511U)
DTC
P0770
Shift Solenoid E Malfunction
(Shift Solenoid Valve SL)
SYSTEM DESCRIPTION
The ECM uses the signals from the Throttle position sensor,
Air–flow meter and crankshaft position sensor to monitor the
engagement condition of the lock–up clutch.
Then the ECM compares the engagement condition of the
lock–up clutch with the lock–up schedule in the ECM memory
to detect mechanical trouble of the shift solenoid valve SL,
valve body and torque converter clutch.
DTC No.
DTC Detecting Condition
Trouble Area
P0770
Lock–up does not occur when driving in the lock–up range
(normal driving at 80 km/h
[
50 mph
]
), or lock–up remains ON
in the lock–up OFF range.
(2 trip detection logic)
Shift solenoid valve SL is stuck open or closed
Valve body blocked up or stuck
Lock–up clutch
INSPECTION PROCEDURE
1
Check solenoid valve SL operation.
PREPARATION:
(a)
Remove the oil pan.
(b)
Remove the shift solenoid valve SL.
CHECK:
(a)
Applying 490 kPa (5 kgf/cm
2
, 71 psi) of compressed air,
check that the solenoid valve does not leak air.
(b)
When battery positive voltage is supplied to the shift sole-
noid valve, check that the solenoid valve opens.
NG
Replace the solenoid valve SL.
OK
DI0CU–01
–
DIAGNOSTICS
AUTOMATIC TRANSAXLE
DI–175
327
1997 LEXUS ES300 (RM511U)
2
Check valve body (See page
NG
Repair or replace the valve body.
OK
Replace the torque converter clutch
(See page
Q04972
Transaxle
Shift Solenoid
Valve SL
2
E3
P–L
27
E10
B+
SL
ECM
DI–176
–
DIAGNOSTICS
AUTOMATIC TRANSAXLE
328
1997 LEXUS ES300 (RM511U)
DTC
P0773
Shift Solenoid E Electrical Malfunction
(Shift Solenoid Valve SL)
CIRCUIT DESCRIPTION
The shift solenoid valve SL is turned ON and OFF by signals from the ECM to control the hydraulic pressure
acting on the lock–up relay valve, which then controls operation of the lock–up clutch.
Fail safe function
If the ECM detects a malfunction, it turns the shift solenoid valve SL OFF.
DTC No.
DTC Detecting Condition
Trouble Area
P0773
Either (a) or (b) are detected for 1 time.
(2 trip detection logic)
(a) Solenoid resistance is 8
Ω
or less short circuit when sole
noid is energized.
(b) Solenoid resistance is 100
k
Ω
or more open circuit when
solenoid is not energized.
Open or short in shift solenoid valve SL circuit
Shift solenoid valve SL
ECM
WIRING DIAGRAM
DI0CV–01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст