Lexus ES300 (1997 year). Manual — part 53
AC0BL–01
N20290
1
2
A
AC–96
–
AIR CONDITIONING
CONDENSER FAN
1653
1997 LEXUS ES300 (RM511U)
CONDENSER FAN
ON–VEHICLE INSPECTION
1.
INSPECT CONDENSER FAN OPERATION
Inspect the fan operation, as shown in the chart below.
Test conditions:
Ignition switch ON
Blower speed control switch position ”HI”
Temperature control dial at ”MAX. COOL”
Install on manifold gauge set”
A/C switch ON
Condition
Fan operation
Engine coolant temperature
83
°
C (181
°
F) or below
Not rotate
Engine coolant temperature
98
°
C (208
°
F) or above
Rotate
Refrigerant pressure is less than
1,520 kPa (15.5 kgf/cm
2
, 220 psi)
Not rotate
Refrigerant pressure is 1,520 kPa
(15.5 kgf/cm
2
, 220 psi) or above
Rotate
If operation is not as specified, proceed to the next inspection.
2.
INSPECT CONDENSER FAN MOTOR OPERATION
(a)
Disconnect the fan connector.
(b)
Connect battery and ammeter.
(c)
Check that the fan rotates smoothly, and then check that
the reading on the ammeter.
Specified amperage: 10.1
±
1.8 A at 20
°
C (68
°
F)
If operation is not as specified, replace the fan motor.
If operation is as specified, check the pressure switch, cooling
fan relays and engine coolant temp. switch.
AC0BM–01
Z19368
Condenser Fan
Upper Radiator Hose
Condenser Fan Connector
Clip
Fan
Fan Shroud
Fan Motor
Non–reusable part
–
AIR CONDITIONING
CONDENSER FAN
AC–97
1654
1997 LEXUS ES300 (RM511U)
COMPONENTS
AC0BN–01
AC–98
–
AIR CONDITIONING
CONDENSER FAN
1655
1997 LEXUS ES300 (RM511U)
REMOVAL
1.
DRAIN ENGINE COOLANT FROM RADIATOR
HINT:
It is not necessary to drain out all the coolant.
2.
DISCONNECT UPPER RADIATOR HOSE FROM RADIATOR
3.
REMOVE CONDENSER FAN
(a)
Disconnect the connector.
(b)
Remove the 3 bolts and fan.
AC0BO–01
I03508
Protrusion
–
AIR CONDITIONING
CONDENSER FAN
AC–99
1656
1997 LEXUS ES300 (RM511U)
DISASSEMBLY
1.
REMOVE FAN
Remove the clip and fan.
NOTICE:
When removing the clip and fan, do not apply too much
force to the motor shaft. And do not scratch the motor
shaft.
HINT:
At the time of installation, please refer to the following item.
Install a new clip from the side opposite the protrusion on the
fan.
2.
REMOVE FAN MOTOR
(a)
Disconnect the lead wire from the fan shroud.
(b)
Remove the 3 screws and fan motor.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст