Lexus ES300 (1997 year). Manual — part 569
RS01J–03
RS–36
–
SUPPLEMENTAL RESTRAINT SYSTEM
AIRBAG SENSOR ASSEMBLY
1380
1997 LEXUS ES300 (RM511U)
REPLACEMENT
REPLACEMENT REQUIREMENT
In the following cases, replace the airbag sensor assembly.
If the SRS has been deployed in a collision.
If the airbag sensor assembly has been found to be faulty in troubleshooting.
If the airbag sensor assembly has been dropped.
CAUTION:
For removal and installation of the airbag sensor assembly, see page
. Be sure to
follow the correct procedure.
RS01K–10
H01345
–
SUPPLEMENTAL RESTRAINT SYSTEM
AIRBAG SENSOR ASSEMBLY
RS–37
1381
1997 LEXUS ES300 (RM511U)
INSTALLATION
NOTICE:
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new parts.
Never reuse the airbag sensor assembly involved in
a collision when the airbag has deployed.
Never repair a sensor in order to reuse it.
1.
INSTALL AIRBAG SENSOR ASSEMBLY
(a)
Using a torx wrench, install the airbag sensor assembly
with 4 screws.
Torx wrench: T40 (Part No.09042–00020 or locally
manufactured tool)
Torque: 21 N·m (210 kgf·cm, 15 ft·lbf)
(b)
Connect the airbag sensor connectors.
NOTICE:
Installation of the connector is done after the sensor
assembly has been installed.
Make sure the sensor assembly is installed with the
specified torque.
If the sensor assembly has been dropped, or there are
cracks, dents or other defects in the case, bracket or
connector, replace the sensor assembly with a new
one.
When installing the senor assembly, take care that
the SRS wiring does not interfere with other parts and
is not pinched between other parts.
After installing , shake the sensor assembly to check
that there is no looseness.
2.
INSTALL REMOVED PARTS
RS01V–24
W03630
Spiral Cable
Front Passenger Airbag Assembly
Steering Wheel Pad
Airbag Sensor Assembly
RS–38
–
SUPPLEMENTAL RESTRAINT SYSTEM
WIRE HARNESS AND CONNECTOR
1382
1997 LEXUS ES300 (RM511U)
WIRE HARNESS AND CONNECTOR
LOCATION
RS01W–02
–
SUPPLEMENTAL RESTRAINT SYSTEM
WIRE HARNESS AND CONNECTOR
RS–39
1383
1997 LEXUS ES300 (RM511U)
INSPECTION
HINT:
The SRS wire harness is integrated with the instrument panel wire harness assembly. The wires for the SRS
wire harness are encased in a yellow corrugated tube and all the connectors in the system are a standard
yellow color.
1.
VEHICLES NOT INVOLVED IN COLLISION
Do a diagnostic system check.
(See page
2.
VEHICLES INVOLVED IN COLLISION
(a)
Do a diagnostic system check.
(See page
)
(b)
Check breaks in all wires of the SRS wire harness, and exposed conductors.
(c)
Check to see if the SRS wire harness connectors are cracked or chipped.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст