Lexus ES300 (1997 year). Manual — part 570
RS01X–02
RS–40
–
SUPPLEMENTAL RESTRAINT SYSTEM
WIRE HARNESS AND CONNECTOR
1384
1997 LEXUS ES300 (RM511U)
REPLACEMENT
In the following cases,replace the wire harness or connector.
If any part of the SRS wire harness or any connector has been found to be faulty in troubleshoot-
ing.
If any part of the SRS wire harness or any connector has been found to be faulty during the
checking items. (See page
)
CAUTION:
If the wire harness used in the SRS is damaged, replace the whole wire harness assembly.
SA0DT–03
–
SUSPENSION AND AXLE
TROUBLESHOOTING
SA–1
1049
1997 LEXUS ES300 (RM511U)
TROUBLESHOOTING
PROBLEM SYMPTOMS TABLE
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely
cause of the problem. Check each part in order. If necessary, replace these parts.
Symptom
Suspect Area
See page
Wander/pulls
1. Tire (Worn or improperly inflated)
2. Wheel alignment (Incorrect)
3. Steering linkage (Loosen or worn)
4. Hub bearings (Worn)
5. Steering gear (Out of adjustment or broken)
6. Suspension parts (Worn)
–
–
–
Bottoming
1. Vehicle (Overloaded)
2. Spring (Weak)
3. Shock absorber (Worn out)
–
Sways/pitches
1. Tire (Worn or improperly inflated)
2. Stabilizer bar (Bent or broken)
3. Shock absorber (Worn out)
Front wheel shimmy
1. Tire (Worn or improperly inflated)
2. Wheels (Out of balance)
3. Shock absorber (Worn out)
4. Wheel alignment (Incorrect)
5. Ball joints (Worn)
6. Hub bearings (Worn)
7. Steering linkage (Loosen or worn)
8. Steering gear (Out of adjustment or broken)
–
–
Abnormal tire wear
1. Tire (Worn or improperly inflated)
2. Wheels (Out of balance)
3. Suspension parts (Worn)
4. Shock absorber (Worn out)
–
SA0DU–01
R03031
R15157
Front
R07928
SA–2
–
SUSPENSION AND AXLE
TIRE AND WHEEL
1050
1997 LEXUS ES300 (RM511U)
TIRE AND WHEEL
INSPECTION
1.
INSPECT TIRE
(a)
Check the tires for wear and for the proper inflation pres-
sure.
Cold inflation pressure:
Tire size
Front, Rear
kPa (kgf/cm
2
or bar, psi)
P205/65R15 92H
*
1
180 (1.8, 26)
*
2
220 (2.2, 32)
*
1
: For all loads including full rated loads
*
2
: For reduced loads (1 to 4 passengers)
(b)
Check the tire runout.
Tire runout: 1.0 mm (0.039 in.) or less
2.
ROTATING TIRES
HINT:
See the illustration for where to rotate each tire.
3.
INSPECT WHEEL BALANCE
(a)
Check and adjust the Off–the–car balance.
(b)
If necessary, check and adjust the On–the–car balance.
Unbalance after adjustment: 8.0 g (0.018 lb) or less
W03084
–
SUSPENSION AND AXLE
TIRE AND WHEEL
SA–3
1051
1997 LEXUS ES300 (RM511U)
4.
CHECK WHEEL BEARING LOOSENESS
(a)
Check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.)
(b)
Check the axle hub deviation.
Maximum: 0.05 mm (0.0020 in.)
5.
CHECK FRONT SUSPENSION FOR LOOSENESS
6.
CHECK STEERING LINKAGE FOR LOOSENESS
7.
CHECK BALL JOINT FOR LOOSENESS
8.
CHECK SHOCK ABSORBER WORKS PROPERLY
Check for oil leaks
Check mounting bushings for wear
Bounce front and rear of the vehicle
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст