Lexus SC300 / Lexus SC400. Manual — part 814
(b) Temporarily connect the strut rod to the axle carrier with the
bolt and nut.
4. INSTALL
BRAKE
CALIPER
Install the brake caliper with the 2 bolts.
Torque: 104 N
⋅
m (1,065 kgf
⋅
cm, 77 ft
⋅
lbf)
5. STABILIZE
SUSPENSION
(a) Install the rear wheel and lower vehicle.
(b) Bounce
the vehicle up and down several times to stabilize the
suspension.
(c) Jack up the vehicle and remove rear wheel.
6.
TORQUE BOLTS AND NUTS
(a) Support the rear axle carrier with a jack.
(b) Torque the bolts and nuts of the strut rod.
Torque: 184 N
⋅
m (1,880 kgf
⋅
cm, 136 ft
⋅
lbf)
(c) Torque the nut.
Torque: 143 N
⋅
m (1,460 kgf
⋅
cm, 106 ft
⋅
lbf)
SA–122
–
SUSPENSION AND AXLE
REAR SUSPENSION
(d) Torque
the nut on the body side of the No.1 lower suspension
arm.
Torque: 184 N
⋅
m (1,880 kgf
⋅
cm, 136 ft
⋅
lbf)
HINT: Align the matchmarks on the adjusting cam and body.
(e) Torque
the nut on the body side of the No.2 lower suspension
arm.
Torque: 184 N
⋅
m (1,880 kgf
⋅
cm, 136 ft
⋅
lbf)
HINT: Align the matchmarks on the adjusting cam and body.
7.
INSTALL REAR WHEEL AND LOWER VEHICLE
Torque: 103 N
⋅
m (1,050 kgf
⋅
cm, 76 ft
⋅
lbf)
8.
CHECK REAR WHEEL ALIGNMENT
(See page
)
–
SUSPENSION AND AXLE
REAR SUSPENSION
SA–123
STABILIZER BAR
COMPONENTS
SA0AJ–04
SA–124
–
SUSPENSION AND AXLE
REAR SUSPENSION
STABILIZER BAR REMOVAL
SA0WD–01
1.
DISCONNECT EXHAUST PIPE
2.
REMOVE BOTH SIDE STABILIZER BAR LINKS
Remove the nuts and the stabilizer bar links.
3. REMOVE
STABILIZER
BAR
Remove both side the bolts and remove the stabilizer bar with
the brackets, cushions and links.
4.
REMOVE BOTH SIDE CUSHIONS AND BRACKETS
STABILIZER BAR LINK BALL JOINT
INSPECTION
SA0UT–03
INSPECT BALL JOINT FOR ROTATION CONDITION
(a) Flip the ball joint stud back and forth 5 times, as shown in the
illustration, before installing the nut.
(b) Using a torque wrench, turn the nut continuously one turn
every 2–4 seconds and take the torque reading on the 5th
turn.
Torque (turning):
0.05 – 1.0 N
⋅
m (0.5 – 10 kgf
⋅
cm, 2.6 – 8.7 in
⋅
lbf)
If not within specification, replace the stabilizer bar link.
–
SUSPENSION AND AXLE
REAR SUSPENSION
SA–125
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст