Lexus SC300 / Lexus SC400. Manual — part 355
19. RECONNECT LH CAMSHAFT POSITION SENSOR
CONNECTOR
20. RECONNECT COLD START INJECTOR CONNECTOR
21. REINSTALL RH NO.3 TIMING BELT COVER
(a) Install the 3 gaskets to the timing belt cover.
(b) Fit the portion A of the timing belt cover, matching it with the
lower high–tension cord cover.
(c) Install the timing belt cover with the 3 bolts.
22. REINSTALL VSV FOR EVAP SYSTEM
Install the VSV with the 2 bolts.
23. REINSTALL LH NO.3 TIMING BELT COVER
(a) Install the 3 gaskets to the timing belt cover.
(b) Install the cord grommet to the high–tension cord (from the
LH ignition coil).
(c) Install the cord grommet to the timing belt cover.
(d) Fit the portion A of the timing belt cover, matching it with the
lower high–tension cord cover.
(e) Install the timing belt cover with the 4 bolts.
–
1UZ–FE ENGINE
ENGINE MECHANICAL
EG–41
24. REINSTALL RH ENGINE WIRE COVER
(a) Fit portions A and B of the engine wire cover, matching them
with the lower high–tension cord cover and No.3 timing belt
cover.
(b) Install the timing belt cover with the bolt.
25. REINSTALL LH ENGINE WIRE COVER
(a) Connect
portions A and B of the engine wire cover to the wire
brackets.
(b) Set the VSV (for the fuel pressure) wire in original position.
(c) Fit portions C and D of the engine wire cover, matching them
with the lower high–tension cord cover and No.3 timing belt
cover.
(d) Install the timing belt cover with the 2 bolts.
26. REINSTALL UPPER HIGH–TENSION CORD COVER
(a) Fit portion A of the upper high–tension cord cover matching
the top of the lower high–tension cord cover.
(b) Push
the front side of the upper high–tension cord cover, and
fit the front side claw groove of the upper high–tension cord
cover to the claw of the lower high –tension cord cover.
(c) Install the upper high–tension cord cover with the 2 bolts.
27. REINSTALL INTAKE AIR CONNECTOR
(a) Connect the end portions of the intake air connector to the
throttle body and air cleaner hose.
(b) Tighten the 2 hose clamps.
(c) Install the bolt holding the intake air connector to the cylinder
head cover.
EG–42
–
1UZ–FE ENGINE
ENGINE MECHANICAL
(d) Connect the following hoses:
(1) Air hose to IAC valve
(2) Air
hose (from air control valve on PS pump) to intake air
connector
28. RECONNECT NEGATIVE TERMINAL CABLE TO
BATTERY
–
1UZ–FE ENGINE
ENGINE MECHANICAL
EG–43
TIMING BELT
EG21Q–01
COMPONENTS FOR REMOVAL AND
INSTALLATION
EG–44
–
1UZ–FE ENGINE
ENGINE MECHANICAL
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст