Lexus SC300 / Lexus SC400. Manual — part 107
ASSEMBLY OF REAR SEAT
(See page
ASSEMBLE THE REAR SEAT PARTS BY FOLLOWING DIS-
ASSEMBLY SEQUENCE IN REVERSE
HINT:
•
Using a hog ring pliers install the new hog ring.
•
If creases occur in the front seat, stretch out the
creases by heating then with a dryer, etc.
If the creases still cannot be removed, spray them lightly
with a vaporizer before applying the hair dryer again.
–
BODY
Seat (Rear Seat)
BO–69
SEAT BELT
COMPONENTS
BO–70
–
BODY
Seat Belt
Front Seat Belt
REMOVAL OF FRONT SEAT BELT
(See page
1.
REMOVE FOLLOWING PARTS:
(a) Front
seat
(b) Rear seat cushion and seat back
(c) Front pillar garnish
(d) Quater trim and roof side inner garnish
2.
REMOVE FRONT SEAT OUTER BELT
(a) Using a screwdriver, pry out the front seat belt anchor
bolt cover.
HINT:
Tape the screwdriver tip before use.
(b) Remove the front seat belt anchor bolt.
(c) Disconnect the connector.
(d) Remove two bolts and the outer belt.
3.
REMOVE FRONT SEAT INNER BELT
(a) Disconnect the connector.
(b) Remove a nut and the inner belt.
–
BODY
Seat Belt (Front Seat Belt)
BO–71
INSTALLATION OF FRONT SEAT BELT
(See page
1.
INSTALL FRONT SEAT INNER BELT
Torque:
43 N
⋅
m (440 kgf
⋅
cm, 32 ft
⋅
lbf)
2.
INSTALL FRONT SEAT OUTER BELT
Torque:
Retractor bolt
43 N
⋅
m (440 kgf
⋅
cm, 32 ft
⋅
lbf)
Anchor bolt
43 N
⋅
m (440 kgf
⋅
cm, 32 ft
⋅
lbf)
HINT:
After installing the anchor bolt, check that the an-
chor turns smoothly.
3.
INSTALL FOLLOWING PARTS:
(a) Quarter trim and roof side inner garnish
(b) Front pillar garnish
(c) Rear seat cushion and seat back
(d) Front
seat
INSPECTION OF FRONT SEAT BELT
[Emergency Locking Retractor (ELR) Type]
1.
RUNNING TEST (IN SAFE AREA)
(a) Fasten the front seat belt.
(b) Drive the car at 10 mph (16 km/h) and make a very hard
stop.
(c) Check that the belt is locked and cannot be extended at
this time.
HINT:
Conduct this test in a safe area. If the belt does not
lock, remove the belt mechanism assembly and conduct the
following static check. Also, whenever installing a new belt
assembly, verify the proper operation before installation.
2.
STATIC TEST
(a) Remove the locking retractor assembly.
(b) Tilt the retractor slowly.
(c) Verify that the belt can be pulled out at a tilt of 15
degrees or less, and cannot be pulled out at over 45
degrees of tilt.
If a problem is found, replace the assembly.
BO–72
–
BODY
Seat Belt (Front Seat Belt)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст