Mercedes-Benz ML320. Manual — part 478
Fig. 34: Identifying Thrust Piece (124 589 02 34 00)
Fig. 35: Identifying Puller (001 589 50 33 00)
Fig. 36: Identifying Clamping Pliers (140 589 01 34 00)
Commercially available tools
CHECKING FOLLOWER JOINT OF STEERING KNUCKLE MOUNT (INSTALLED) - AR33.20-P-0426GH
MODEL 163.113 /128 /136 /154 /157 /172 /174 /175
Number
Designation
WH58.30-Z-1009-02A
Pliers for circlip, inner
2001 Mercedes-Benz ML320
1998-2005 DRIVELINE/AXLES Front Axle - 163 Chassis
me
Fig. 37: Identifying Follower Joint Of Steering Knuckle Mount
PRESSING OUT AND ATTACHING SUPPORTING JOINT AT STEERING KNUCKLE - AR33.20-P-0440-01GH
Wheel location, hub
Fig. 38: Identifying Prong Wrench (385 589 00 07 00)
Remove
1. Push supporting joint (7) out of steering knuckle using suitable tool.
Inspect
1 Raise front of vehicle
2 Check rubber boot (8f) for cracks and damage
3
Check play in follower joint (8) by firmly
pulling and pushing on the front wheel while
feeling the ball joint at the same time.
If inspection indicates that upper
control (6) arm should be replaced,
proceed as follows: ?
Upper control arm, removal and
installation
AR33.20-P-
0500GH
Number
Designation
Model Series 163
BA33.20-P-1003-01D Locking slotted nut, supporting joint to steering knuckle
NM 300
2001 Mercedes-Benz ML320
1998-2005 DRIVELINE/AXLES Front Axle - 163 Chassis
me
Fig. 39: Identifying Steering Knuckle Supporting Joint
Install
2. Insert supporting joint (7) and attach locking grooved nut (7)
.
3. Pull in supporting joint (7)
using claw-type wrench (044) until it abuts.
Fig. 40: Identifying Steering Knuckle Supporting Joint And Attaching Locking Grooved Nut
PRESSING OFF AND ATTACHING SUPPORTING JOINT AT LOWER WISHBONE - AR33.20-P-0440-02GH
Wheel location, hub
Number
Designation
Model Series 163
BA33.20-P-1002-01D Self-locking nut, supporting joint to steering knuckle
NM 85
2001 Mercedes-Benz ML320
1998-2005 DRIVELINE/AXLES Front Axle - 163 Chassis
me
Fig. 41: Identifying Thrust Piece (140 589 00 63 00)
Pressing off
1. Unscrew self-locking nut from supporting joint (7).
2. Mount pressure piece (044a).
3. Press supporting joint (7) out of wishbone using two-arm puller.
4. Remove puller.
Installation
5. Clean tapered connection.
6. Replace self-locking nut and screw on
.
Fig. 42: Identifying Lower Wishbone Supporting Joint, Mount Pressure Piece & Two-Arm Puller
REPLACE SUPPORTING JOINT - AR33.20-P-0440GH
MODEL 163.113 /128 /136 /154 /157 /172 /174 /175
2001 Mercedes-Benz ML320
1998-2005 DRIVELINE/AXLES Front Axle - 163 Chassis
me
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст