Mercedes-Benz ML320. Manual — part 319
Parts ordering notes
RETROFITTING TRAFFIC PRO WIRING HARNESS - AZ82.61-P-0002-01H
Model 163 with transmission 722 up to 30.6.2000
1. Prepare adapter wiring harness (4) as shown in figure.
2. Cut off orange (or) lead for reverse lamp signal (2) at connector (C) and provide with contact spring.
Connector (C) no longer required after cutting off.
and navigation system
sound system
Only on vehicles
without sound system
AZ82.61-P-0001-02I
8
Reassemble vehicle, 5-1
9
Carrying out start-up and
function check
AZ82.61-P-0001-04A
Part no.
Designation
Quantity
B6 782 2500
TrafficStar navigation system
parts kit
1
B6 782 2514
TrafficStar navigation system with
precious wood finish, burr walnut
veneer
1
B6 782 2519
CAN bus adapter parts kit
1
B6 782 2595
TrafficStar wiring harness with
sound system
1
B6 782 2594
TrafficStar wiring harness without
sound system
1
B6 782 2596
CAN bus wiring harness
1
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
Fig. 337: Identifying Traffic Pro Wiring Harness
3. Insert contact spring of orange lead for reverse lamp signal (2) into radio connector (A) chamber 2 of
adapter wiring harness (4).
Fig. 338: Identifying Radio Connector And Adapter Wiring Harness
4. Route adapter wiring harness (4) in vehicle along existing wires as shown in figure.
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
Fig. 339: Identifying Telephone/GPS Antenna Splitter And CAN Bus Adapter
5. Connect adapter wiring harness (4) to radio counter connector (7) on standard wiring harness and Traffic
Pro navigation system (1).
Fig. 340: Identifying Adapter Wiring Harness And Radio Counter Connector
6. Connect antenna extension lead (41) to Traffic Pro navigation system as shown in figure.
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
Fig. 341: Identifying Antenna Extension Lead
7. Route tieout to CAN bus adapter (5) from adapter wiring harness (4) as shown in figure toward rear on
middle tunnel.
Fig. 342: Identifying CAN Bus Adapter And Adapter Wiring Harness
8. Position CAN bus adapter mount on center console brace as shown in figure and mark holes (arrows).
9. Drill 6.2 mm dia. mounting holes
Fig. 343: Identifying Mark Holes
10. Fasten CAN bus adapter (5) with self-tapping screws from CAN bus adapter parts kit.
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст