Great Wall Hover. Manual — part 46
d. Tighten the adjusting bolt to make the extension length of the bolt
equal to the length before remove.
2. For new torsion bar spring
a. Remove the wheel.
b. Coat thin grease on the spline of the torsion bar spring.
c. Install the torsion bar spring on the torsion bar base.
d. Lower the lower arm to the lower limitation position; install the
adjusting arm in the torsion bar spring with the angle that the
adjusting bolt just can be screwed on the upper adjusting block.
e. Tighten the adjusting bolt to the specified torque.
N u t t i g h t e n i n g l i m i t a t i o n : A i s a b o u t 3 0 - 3 5 m m ; i f A >
35mm, then it is adjusted through height of adjusting arm.
f. Install the wheel; remove the bracket; bounce the vehicle for
several times to make the suspension enters into the stable
status.
g. Rotate the adjusting bolt and adjust the ground clearance of
chassis (Refer to 4-Wheel Alignment).
2. Disconnect the vibration damper from the lower
arm.
3. Disassembly of torsion bar spring
(Refer to Section “Torsion Bar Spring”)
Lower suspension arm
Removal of lower suspension arm
1. Disconnect the connecting rod of stabilizer bar
from the lower arm
a. Use the jack to support the lower arm.
b. Remove the connecting nut; disconnect the connecting rod of
sta bilizer bar form the lower arm.
5. Remove the front shaft of lower arm
a. Make the mark on the adjusting cam.
special tools
b.Remove the nut and front shaft of lower arm.
6. Remove the rear shaft of lower arm
Screw off the nut; remove the rear shaft of lower arm shaft; remove the
lower suspension arm.
Replacement of lower suspension arm bush
1. Removal of short bush of lower suspension arm
Use the special tools to press the short bush from the lower arm.
2. Installation of short bush of lower suspension arm
Use the special tools to press the new short bush in the lower arm.
Remarks: Do not coat the bush with the grease.
special tools
special tools
3. Removal of long bush of lower suspension arm
Use the special tools to remove the long bush.
special tools
4. Installation of longbushoflowersuspensionarmUse
the special tools to install the new bush.
Remarks: Do not coat the bush with the grease.
Installation of lower suspension arm
1. Installation of lower suspension arm
a. Install the rear shaft of lower arm and tighten the nut to the
specified torque.
Tightening force: 290
25N
m
b. Install the front shaft of lower arm and screw on the nut
temporarily.
2. Installation of front hub and steering knuckle
assem bly
(Refer to section “Front Hub and Steering Knuckle”)
3. Install the vibration damper on the lower suspension
arm.
Install the vibration damper on the lowersuspensionarmbracket.
Tightening force: 90
10N
m
4. Connect the stabi lizerbar to the lower suspension
arm
Tightening force: 63
5N
m
special tools
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст