Mazda 6. Manual — part 274
REAR SUSPENSION
R–31
R
REAR UPPER ARM REMOVAL/INSTALLATION
A6E741628210W01
Caution
• Performing the following procedures without first removing the ABS wheel-speed sensor may
possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the
following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate
place where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the rear wheel alignment.
(See
.
A6E7416W009
1
ABS wheel-speed sensor
2
Parking brake cable
3
Bolt (rear shock absorber lower side)
(See
R–32 Bolt (Rear Shock Absorber Lower Side)
4
Bolt (trailing link front side)
5
Bolt (rear upper arm)
(See
R–32 Bolt (Rear Upper Arm) Removal Note
6
Rear upper arm
7
Rear upper arm bushing
(See
R–32 Rear Upper Arm Bushing Removal Note
)
(See
R–32 Rear Upper Arm Bushing Installation
)
R–32
REAR SUSPENSION
Bolt (Rear Shock Absorber Lower Side) Removal Note
1. Support the trailing link with a jack.
Bolt (Rear Upper Arm) Removal Note
1. Loosen the bolts on the inner and outer side of the lateral link.
Rear Upper Arm Bushing Removal Note
1. Press the upper arm bushing out using the SSTs.
Rear Upper Arm Bushing Installation Note
1. Mark the new bushing as shown in the figure.
2. Press the bushing in to the marking using the
SSTs.
A6E7416W005
A6E7416W010
A6E7416W011
A6E7416W012
REAR SUSPENSION
R–33
R
3. Verify that clearance distance A—B is 14.0 mm—
16.0 mm {0.56 in-0.62 in}.
End Of Sie
REAR LATERAL LINK REMOVAL/INSTALLATION
A6E741628600W01
1. Remove the rear lateral link.
Caution
• When working near left rear suspension, avoid any impact to the fuel tank.
2. Measure the length L shown in the figure for
proper installation.
3. Temporarily loosen a locknut of the rear lateral
link.
4. Install the rear lateral link.
5. Inspect the rear wheel alignment.
(See
A6E7416W013
B6U0214W015
A
C
C
A
D
D
B
B
93.1—126.4
{9.50—12.88, 68.67—93.22}
REAR
LATERAL
LINK
N·m {kgf·m, ft·lbf}
93.1—126.4
{9.50—12.88,
68.67—93.22}
B6U0214W014
L
R–34
REAR SUSPENSION
End Of Sie
REAR STABILIZER REMOVAL/INSTALLATION
A6E741628100W01
1. Remove the rear auto leveling sensor.
(See
T–32 REAR AUTO LEVELING SENSOR REMOVAL/INSTALLATION
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the headlight zeroset.
(See
.)
.
End Of Sie
A6E7416W004
1
Stabilizer control link
2
Stabilizer bracket
3
Bushing
4
Rear stabilizer
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст