Mazda 6. Manual — part 97
ELECTRICAL SYSTEM
GI–19
GI
• Connectors can be disconnected by pressing or
pulling the lock lever as shown.
Locking connector
• When locking connectors, listen for a click
indicating they are securely locked.
Inspection
• When a tester is used to inspect for continuity or
measuring voltage, insert the tester probe from
the wiring harness side.
• Inspect the terminals of waterproof connectors
from the connector side since they cannot be
accessed from the wiring harness side.
Caution
• To prevent damage to the terminal, wrap
a thin wire around the tester probe before
inserting into terminal.
WGIWXX0042E
X3U000WB1
X3U000WB2
WGIWXX0045E
GI–20
ELECTRICAL SYSTEM
Terminals
Inspection
• Pull lightly on individual wires to verify that they
are secured in the terminal.
Replacement
• Use the appropriate tools to remove a terminal as
shown. When installing a terminal, be sure to
insert it until it locks securely.
• Insert a thin piece of metal from the terminal side
of the connector and with the terminal locking tab
pressed down, pull the terminal out from the
connector.
Sensors, Switches, and Relays
• Handle sensors, switches, and relays carefully.
Do not drop them or strike them against other
objects.
Wiring Harness
Wiring color codes
• Two-color wires are indicated by a two-color code symbol.
• The first letter indicates the base color of the wire and the second the color of the stripe.
X3U000WB4
X3U000WB5
X3U000WB6
CODE
COLOR
CODE
COLOR
B
Black
O
Orange
BR
Brown
P
Pink
G
Green
R
Red
GY
Gray
V
Violet
L
Blue
W
White
LB
Light Blue
Y
Yellow
LG
Light Green
X3U000WB7
ELECTRICAL SYSTEM
GI–21
GI
Fuse
Replacement
• When replacing a fuse, be sure to replace it with
one of the same capacity. If a fuse fails again, the
circuit probably has a short and the wiring should
be inspected.
• Be sure the negative battery terminal is
disconnected before replacing a main fuse.
• When replacing a pullout fuse, use the fuse
puller.
Direction of View for Connector
Part-side connector
Direction of view is from the terminal side.
*
: Part names are shown only when there are
multiple connector drawings.
YMU000WA1
YMU000WAK
WGIWXX0100E
GI–22
ELECTRICAL SYSTEM
Vehicle-harness-side connector
Direction of view is from the harness side.
*
: Part names are shown only when there are
multiple connector drawings.
Other
Because vehicle-harness-side connectors, such as
the DLC 2, have to be viewed from the terminal side,
the direction of view is from the terminal side.
End Of Sie
ELECTRICAL TROUBLESHOOTING TOOLS
A6E201700006W03
Jumper wire
• A jumper wire is used to create a temporary
circuit. Connect the jumper wire between the
terminals of a circuit to bypass a switch.
Caution
• Do not connect a jumper wire from the
power source line to a body ground. This
may cause burning or other damage to
wiring harnesses or electronic
components.
WGIWXX0101E
WGIWXX0102E
X3U000WBB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст