Mazda 6. Manual — part 408
III–18
PANEL REPLACEMENT
REAR FENDER PANEL REMOVAL
A6E981274100B01
SEDAN
Caution
• Avoid cutting with a blowtorch or similar tools as the insulator (shaded area) is flammable.
1. The rear fender panel and the rear pillar inner are joined with glue at the wheel arch line. Use a chisel or other
to separate the rear fender panel from the rear pillar inner, then remove the rear fender panel.
A6E9812B017
PANEL REPLACEMENT
III–19
III
5HB
Caution
• Avoid cutting with a blowtorch or similar tools as the insulator (shaded area) is flammable.
1. The rear fender panel and the rear pillar inner are joined with glue at the wheel arch line. Use a chisel or other
to separate the rear fender panel from the rear pillar inner, then remove the rear fender panel.
End Of Sie
A6E9812B018
III–20
PANEL REPLACEMENT
REAR FENDER PANEL INSTALLATION
A6E981274100B02
SEDAN
1. When joining the new and old parts, temporarily install and fit the new part in position, measure each dimension
according to the body dimension, then adjust the position to align it to the standard dimensions.
2. Drill holes for plug welds before installing new parts.
3. Before installing new parts, apply spot weld sealer to the wheel arch line.
4. After trial-fitting new parts, make sure the related parts fit properly.
A6E9812B019
PANEL REPLACEMENT
III–21
III
5HB
1. When joining the new and old parts, temporarily install and fit the new part in position, measure each dimension
according to the body dimension, then adjust the position to align it to the standard dimensions.
2. Drill holes for plug welds before installing new parts.
3. Before installing new parts, apply spot weld sealer to the wheel arch line.
4. After trial-fitting new parts, make sure the related parts fit properly.
End Of Sie
A6E9812B020
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст