Mazda CX-9 Grand Touring. Manual — part 95
Substitution SST
49 F026 102
Outer diameter: 27 mm {1.06 in} or more
Inner diameter: 15-18 mm {0.60-0.70 in}
6. Install the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
7. Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-
3.7] .)
8. Connect the negative battery cable.
Fig. 55: Tapping Oil Seal
Courtesy of MAZDA MOTORS CORP.
AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [AW6A-EL, AW6AX-
EL]
1. Disconnect the negative battery cable.
2. Remove the following parts.
1. Battery and battery tray (See BATTERY REMOVAL/INSTALLATION [MZI-3.7] .)
2. Air cleaner component (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-
3.7] .)
3. Engine cover
4. Windshield wiper arm and blade (See WINDSHIELD WIPER ARM AND BLADE
REMOVAL/INSTALLATION .)
5. Cowl grille (See COWL GRILLE REMOVAL/INSTALLATION .)
6. Cowl panel (See COWL PANEL REMOVAL/INSTALLATION .)
7. Front wheel
8. Splash shield
9. Side cover
10. Propeller shaft (transfer side) (See PROPELLER SHAFT REMOVAL/INSTALLATION .)
2008 Mazda CX-9 Grand Touring
2008 TRANSMISSION Automatic Transaxle (AW6A-EL, AW6AX-EL) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:29:31 AM
Page 49
© 2005 Mitchell Repair Information Company, LLC.
3. Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [AW6A-EL,
AW6AX-EL].)
4. Remove in the order shown in the figure.
5. Install in the reverse order of removal.
6. Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT
[AW6A-EL, AW6AX-EL].)
7. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [AW6A-EL, AW6AX-
EL].)
LINE PRESSURE TEST REFERENCE
WARNING:
Improperly jacking a transaxle is dangerous. It can slip off the
jack and may cause serious injury.
CAUTION:
To prevent the torque converter and transaxle from separating,
remove the transaxle without tilting it toward the torque
converter.
Service item
Test item
Line pressure test Stall test Time lag test Time lag test
ATX replacement
X
ATX overhaul
X
X
X
X
Torque converter replacement
X
X
Oil pump replacement
X
Control valve body component
X
Clutch system replacement
X
X
X
X : Test to be performed after the service work
2008 Mazda CX-9 Grand Touring
2008 TRANSMISSION Automatic Transaxle (AW6A-EL, AW6AX-EL) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:29:31 AM
Page 50
© 2005 Mitchell Repair Information Company, LLC.
Fig. 56: View Of Automatic Transaxle Components & Torque Specifications (1 Of 2)
Courtesy of MAZDA MOTORS CORP.
AWD
2008 Mazda CX-9 Grand Touring
2008 TRANSMISSION Automatic Transaxle (AW6A-EL, AW6AX-EL) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:29:31 AM
Page 51
© 2005 Mitchell Repair Information Company, LLC.
Fig. 57: View Of Automatic Transaxle Components & Torque Specifications (2 Of 2)
Courtesy of MAZDA MOTORS CORP.
TORQUE CONVERTER NUTS REMOVAL NOTE
1. Remove the cover as shown in the figure.
2. Align the holes by turning the torque converter.
Fig. 58: Identifying Fastener & Cover
Courtesy of MAZDA MOTORS CORP.
3. Insert a flathead screwdriver through the converter housing service hole, and lock the drive plate.
2008 Mazda CX-9 Grand Touring
2008 TRANSMISSION Automatic Transaxle (AW6A-EL, AW6AX-EL) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:29:31 AM
Page 52
© 2005 Mitchell Repair Information Company, LLC.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст