Mazda Protege 5. Manual — part 204
ON-BOARD DIAGNOSTIC
04–02–18
End Of Sie
DTC B1342 (61)
A3U040243000W10
Diagnostic procedure
End Of Sie
DTC B1318 (63)
A3U040243000W11
Caution
••••
When attaching the tester lead to the ABS HU/CM or the ABS HU/CM harnesses connector the SST
(49 G066 001) must be used. (See 04–13–6 ABS HYDRAULIC UNIT (HU)/CONTROL MODULE (CM)
INSPECTION.)
Diagnostic procedure
DTC
B1342 (61)
ABS HU/CM (CM)
DETECTION
CONDITION
The on-board diagnostic function detects computer malfunction.
POSSIBLE
CAUSE
•
Malfunction of ABS HU/CM
STEP
INSPECTION
ACTION
1
VERIFY CURRENT STATUS OF
MALFUNCTION
•
Clear DTC from memory.
(See 04–02–4 DTCs Clearing Procedure)
•
Start engine and drive vehicle at 10 km/h
{6.2 mph} or above.
•
Is same DTC present?
Yes
Replace ABS HU/CM, then go to next step.
No
Go to next step.
2
VERIFY AFTER REPAIR PROCEDURE
•
Is there any other DTC present?
Yes
Go to applicable DTC inspection.
No
Troubleshooting completed.
DTC
B1318 (63)
ABS HU/CM power supply
DETECTION
CONDITION
•
Voltage at Z terminal of ABS HU/CM drops below 10 V when driving vehicle.
POSSIBLE
CAUSE
•
Low power supply
•
Battery and/or generator malfunction
•
Poor ground or open circuit of ground
STEP
INSPECTION
ACTION
1
INSPECT ABS HU/CM POWER SUPPLY
CIRCUIT FOR OPEN CIRCUIT
•
Turn ignition key to OFF.
•
Disconnect ABS HU/CM connector.
•
Connect SST (adapter harness) to ABS HU/
CM connector (harness side) with ABS HU/
CM disconnected.
•
Start engine.
•
Measure voltage between terminal Z of SST
(harness side) and ground.
•
Is voltage above 10 V?
Yes
Go to next step.
No
Go to Step 3.
1712-1U-01G(04-02).fm 18 ページ 2001年6月29日 金曜日 午前10時1分
ON-BOARD DIAGNOSTIC
04–02–19
04–02
End Of Sie
2
INSPECT ABS HU/CM GROUND CIRCUIT
FOR POOR GROUND AND OPEN CIRCUIT
•
Turn ignition key to OFF.
•
Measure resistance between terminal AA of
SST and ground.
•
Is resistance within 0—1 ohm?
Yes
Go to Step 5.
No
If there is no continuity:
•
Repair or replace harness for open between ABS HU/
CM and ground, then go to Step 5.
If resistance is not within 0—1 ohm:
•
Repair or replace harness for poor ground then go to
Step 5.
3
INSPECT BATTERY POWER
•
Inspect battery.
(See 01–50–1 ENGINE TECHNICAL DATA)
•
Is it okay?
Yes
Go to next step.
No
Replace battery, then go to Step 5.
4
INSPECT GENERATOR
•
Inspect generator.
(See 01–17–3 GENERATOR INSPECTION)
•
Is it okay?
Yes
Go to next step.
No
Repair or replace generator, then go to Step 5.
5
VERIFY TROUBLESHOOTING COMPLETED
•
Make sure to reconnected all disconnected
connectors.
•
Clear DTC from memory.
(See 04–02–4 DTCs Clearing Procedure)
•
Is same DTC present?
Yes
Replace ABS HU/CM, then go to next step.
No
Go to next step.
6
VERIFY AFTER REPAIR PROCEDURE
•
Is there any other DTC present?
Yes
Go to applicable DTC inspection.
No
Troubleshooting completed.
STEP
INSPECTION
ACTION
1712-1U-01G(04-02).fm 19 ページ 2001年6月29日 金曜日 午前10時1分
SYMPTOM TROUBLESHOOTING
04–03–1
04–03
04–03
SYMPTOM TROUBLESHOOTING
ABS SYSTEM DIAGRAM . . . . . . . . . . . . 04–03–2
FOREWORD . . . . . . . . . . . . . . . . . . . . . . 04–03–3
ABS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 04–03–3
Foreword . . . . . . . . . . . . . . . . . . . . . . . 04–03–3
Precaution . . . . . . . . . . . . . . . . . . . . . . 04–03–3
SYMPTOM TROUBLESHOOTING . . . . . 04–03–4
ABS Symptom Troubleshooting . . . . . . 04–03–4
Quick Diagnosis Chart . . . . . . . . . . . . . 04–03–5
NO.1 NEITHER ABS WARNING
LIGHT NOR BRAKE SYSTEM
WARNING LIGHT ILLUMINATE . . . . . . 04–03–5
NO.2 ABS WARNING LIGHT DOES
NOT ILLUMINATE. . . . . . . . . . . . . . . . . 04–03–6
NO.3 BRAKE SYSTEM WARNING
LIGHT DOES NOT ILLUMINATE . . . . . . 04–03–7
NO.4 ABS WARNING LIGHT AND
BRAKE SYSTEM WARNING LIGHT
STAY ON . . . . . . . . . . . . . . . . . . . . . . . . 04–03–8
NO.5 ABS WARNING LIGHT
STAYS ON . . . . . . . . . . . . . . . . . . . . . . . 04–03–10
NO.6 BRAKE SYSTEM WARNING
LIGHT STAYS ON . . . . . . . . . . . . . . . . . 04–03–12
NO.7 BRAKE SYSTEM
MALFUNCTION . . . . . . . . . . . . . . . . . . . 04–03–13
End of Toc
1712-1U-01G(04-03).fm 1 ページ 2001年6月29日 金曜日 午前10時2分
SYMPTOM TROUBLESHOOTING
04–03–2
ABS SYSTEM DIAGRAM
A3U040343000W01
End Of Sie
A3U0402W001
1712-1U-01G(04-03).fm 2 ページ 2001年6月29日 金曜日 午前10時2分
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст