Mazda X-5. Manual — part 82
AUTOMATIC TRANSMISSION [SJ6A-EL]
05–13–31
05–13
COUPLER COMPONENT OUTLINE [SJ6A-EL]
E5U051321101N06
• The coupler component are installed on the transmission case as the grouped connectors of the TFT sensor
and solenoids.
.
End Of Sie
SHIFT CONTROL OUTLINE [SJ6A-EL]
E5U051318901N06
• Based on the shift diagram, shift solenoids A, B, C, D, E, F, and G are controlled according to the vehicle speed
and the throttle opening angle, and the shift control of the transmission is performed.
• When certain conditions are met, the TCM selects a shift mode suitable to the driving conditions and
automatically switches to the mode to perform smooth shifting.
POWER MODE
• The POWER MODE in which the shift point is set higher than the normal shift point is automatically
selected when certain conditions are met so that high-engine speed high-output conditions are available.
DOWN SLOPE MODE
• While the vehicle is being driven on a down slope, the TCM determines that the vehicle is being driven on a
down slope based on the signals and output engine speed from the PCM, and switches the driving mode to
the DOWN SLOPE MODE. Due to this, load to the brake is reduced.
UP SLOPE MODE
• When the vehicle is climbing a slope, the TCM determines that the vehicle is being driven on an up slope
based on the signals and output engine speed from the PCM, and switches the driving mode to the UP
SLOPE MODE. Due to this, reduction in traction is prevented.
End Of Sie
LINE PRESSURE
CONTROL SOLENOID
SHIFT
SOLENOID E
SHIFT
SOLENOID F
SHIFT
SOLENOID D
SHIFT
SOLENOID G
SHIFT
SOLENOID A
SHIFT
SOLENOID B
SHIFT
SOLENOID C
TCC CONTROL
SOLENOID
TFT SENSOR
A
B
H
J
L
N
D
F
G
E
C
I
K
M
O
E5U513ZS5032
Terminal
No.
Signal
A
TFT sensor (–)
B
TFT sensor (+)
C
Shift solenoid G (–)
D
Shift solenoid G (+)
E
Shift solenoid F (–)
F
Shift solenoid F (+)
G
TCC control solenoid (–)
H
TCC control solenoid (+)
I
Line pressure control solenoid (–)
J
Line pressure control solenoid (+)
K
Shift solenoid E
L
Shift solenoid D
M
Shift solenoid C
N
Shift solenoid B
O
Shift solenoid A
Terminal
No.
Signal
AUTOMATIC TRANSMISSION [SJ6A-EL]
05–13–32
MANUAL MODE SHIFT CONTROL STRUCTURE [SJ6A-EL]
E5U051318901N07
Features
• The manual mode shift control is activated by moving the selector lever from the D to M range position (selector
lever is shifted over toward driver side).
• Manual mode shift control with a manual shifting system allowing selection of gear positions by manual
operation of the selector lever forward (–) and back (+) has been adopted. Moreover, engine braking for 1—
4GR in manual mode according to the gear ratio is available.
— Shifting between 1GR and 2GR when the vehicle is stopped is possible. Moreover, when shifting from the D
to M range while driving, the same gear position is maintained.
— Consecutive shifting in the M range has been adopted. When shifting down from M range 6GR or 5GR, one
gear can be skipped over by rapidly tapping the selector lever two times in the down-shift (–) direction.
• Specialized manual mode selector lever position and gear position indicator lights, built into the instrument
cluster, have been adopted. The gear position indicator light displays the selected gear position while in manual
mode.
— The selector indicator light includes a selector lever position indicator that displays selector lever positions
and, in M range, a gear position indicator light that displays gear positions.
Structure
System diagram
End Of Sie
MANUAL MODE SHIFT CONTROL OPERATION [SJ6A-EL]
E5U051318901N08
Manual Mode Shift
• When the selector lever is shifted over from the D to M range position, the M range switch in the selector lever
component turns on, sending a manual mode command signal to the TCM which activates the manual mode
shift control.
• When in manual mode and the selector lever is operated in the back (+) direction, the up switch in the selector
lever component is turned on and an up-shift command signal is input to the TCM.
— The TCM, triggered by the up-shift command signal, carries out shifting by outputting an operation signal to
the shift control solenoid.
PCM
TCM
TR SWITCH
TFT SENSOR
M RANGE SWITCH
UP SWITCH
DOWN SWITCH
GEAR POSITION INDICATOR LIGHT
SELECTOR INDICATOR LIGHT
AT WARNING LIGHT
ENGINE
TRANSMISSION
SELECTOR LEVER COMPONENT
UP SWITCH
DOWN SWITCH
STEERING SHIFT SWITCH
INSTRUMENT CLUSTER
E5U513ZS5033
AUTOMATIC TRANSMISSION [SJ6A-EL]
05–13–33
05–13
• Conversely, when the selector lever is operated in the forward (–) direction, the down switch in the selector lever
component turns on, and a down-shift command signal is input to the TCM.
— The TCM, triggered by the down-shift command signal, carries out shifting by outputting an operation signal
to the shift control solenoid if the vehicle speed is less than the set speed and the gear position is 2GR or
above.
• The up/down operation of the steering shift switch is the same as the manual operation of the selector lever.
• The TCM utilizes a specialized M range automatic shift diagram. Due to this, restriction of manual shift demand
and automatic control of downshifting is carried out, reducing load on the AT, preventing engine over-rev and
ensuring drive stability.
Condition
Shift control
Note
1GR
→2GR up-shift command,
at low speed
• To reduce load on the AT, upshifting is
inhibited until vehicle reaches speed possible
for upshifting
—
2GR
→3GR up-shift command,
at low speed
3GR
→4GR up-shift command,
at low speed
4GR
→5GR up-shift command,
at low speed
5GR
→6GR up-shift command,
at low speed
5GR
→6GR up-shift command,
low ECT
• To reduce load on the AT, upshifting to 6GR
is inhibited
6GR
→5GR down-shift
command, above set speed
• To prevent engine over-rev, downshifting is
inhibited until vehicle reaches speed possible
for downshifting
• Gear position indicator light flash to
alert driver
5GR
→4GR down-shift
command, above set speed
4GR
→3GR down-shift
command, above set speed
3GR
→2GR down-shift
command, above set speed
2GR
→1GR down-shift
command, above set speed
In 6GR deceleration, speed
goes below coast-down set
speed (deceleration down-
shift)
• To assure drive stability, automatically
downshifts from 6GR to 5GR
—
In 5GR deceleration, speed
goes below coast-down set
speed (deceleration down-
shift)
• To assure drive stability, automatically
downshifts from 5GR to 4GR
In 4GR deceleration, speed
goes below coast-down set
speed (deceleration down-
shift)
• To assure drive stability, automatically
downshifts from 4GR to 3GR
In 3GR deceleration, speed
goes below coast-down set
speed (deceleration down-
shift)
• To assure drive stability, automatically
downshifts from 3GR to 2GR
In 2GR deceleration, speed
goes below coast-down set
speed (deceleration down-
shift)
• To assure drive stability, automatically
downshifts from 2GR to 1GR
Wide open throttle at 125—
190 km/h {78—118 mph} in
6GR
• To improve acceleration performance, 6GR
to 5GR kickdown occurs
—
Wide open throttle at 78—124
km/h {49—77 mph} in 5GR
• To improve acceleration performance, 5GR
to 4GR kickdown occurs
Wide open throttle at 50—77
km/h {32—48 mph} in 4GR
• To improve acceleration performance, 4GR
to 3GR kickdown occurs
Wide open throttle at 15—49
km/h {10—31 mph} in 3GR
• To improve acceleration performance, 3GR
to 2GR kickdown occurs
AUTOMATIC TRANSMISSION [SJ6A-EL]
05–13–34
Shift Diagram
End Of Sie
AT WARNING LIGHT FUNCTION [SJ6A-EL]
E5U051321101N07
• The AT warning light illuminates to alert the driver of a malfunction in the automatic transmission.
End Of Sie
4
5
5
6
6
3
4
1
2
3
4
2
1
4
3
5
4
3
2
4
5
2
3
VEHICLE SPEED km/h {mph}
TCC OPERATION AVAILABLE
5
THR
O
TTLE OPENING
5GR
TCC OPERATION
OFF
5GR
TCC OPERATION
ON
6GR
TCC OPERATION
ON
6GR
TCC OPERATION
OFF
6
2
3
1
2
230
{143}
220
{137}
210
{131}
200
{124}
190
{118}
180
{112}
170
{105}
160
{99}
150
{93}
140
{87}
130
{81}
120
{74}
110
{68}
90
{56}
100
{62}
80
{50}
70
{43}
50
{31}
60
{37}
30
{19}
40
{25}
10
{6.2}
20
{12}
0
{0}
8/8
7/8
6/8
5/8
4/8
3/8
2/8
1/8
0/8
4
5
5
2
3
3
4
DOWNSHIFTING IS INHIBITED UNTIL VEHICLE
REACHES SPEED POSSIBLE FOR DOWNSHIFTING
WHEN DECELERATING BELOW SET VEHICLE SPEED,
EXECUTES AUTOMATIC DOWNSHIFTING
UPSHIFTING IS INHIBITED UNTIL VEHICLE
REACHES SPEED POSSIBLE FOR UPSHIFTING
WHEN WIDE OPEN THROTTELE,
EXECUTES KICKDOWN
E5U513ZS5034
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст