Mazda MX-5 Miata / Grand Touring. Manual — part 24
If there is any malfunction, replace the front ABS wheel-speed sensor.
REAR ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION
1. Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
2. Remove the partition board. (See PARTITION BOARD REMOVAL/INSTALLATION .)
3. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
4. Remove the fuel-filler pipe protector. (See FUEL TANK REMOVAL/INSTALLATION [LF] .)
5. Remove in the order indicated in Fig. 14 .
6. Install in the reverse order of removal.
Fig. 14: Identifying Rear ABS Wheel-Speed Sensor (With Torque Specifications)
Courtesy of MAZDA MOTORS CORP.
REAR ABS WHEEL-SPEED SENSOR INSPECTION
INSTALLATION VISUAL INSPECTION
1. Inspect the following items:
If there is any malfunction, replace the applicable part.
1. Excessive looseness or play of the ABS wheel-speed sensor
2. Deformation of the ABS wheel-speed sensor
3. Deformation or damage of the ABS sensor rotor
2008 Mazda MX-5 Miata Grand Touring
2008 BRAKES Antilock Brake System - MX-5 Miata
CLEARANCE INSPECTION
1. Verify the clearance between the ABS sensor rotor and the ABS wheel-speed sensor.
If there is any malfunction, check for improper installation, and replace if necessary.
Clearance
0.8-1.6 mm {0.032-0.062 in}
Fig. 15: Inspecting ABS Sensor-To-Rotor Clearance
Courtesy of MAZDA MOTORS CORP.
SENSOR OUTPUT VALUE INSPECTION
1. Turn the ignition switch off.
2. Connect the M-MDS or equivalent to the DLC-2.
2008 Mazda MX-5 Miata Grand Touring
2008 BRAKES Antilock Brake System - MX-5 Miata
Fig. 16: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
3. Select the following PIDs using the M-MDS or equivalent:
LR_WSPD
(LR wheel-speed sensor)
RR_WSPD
(RR wheel-speed sensor)
4. Start the engine and drive the vehicle.
5. Verify that the display of the M-MDS or equivalent shows the same value as the speedometer.
If there is any malfunction, replace the rear ABS wheel-speed sensor.
2008 Mazda MX-5 Miata Grand Touring
2008 BRAKES Antilock Brake System - MX-5 Miata
2008 BRAKES
Conventional Brake System - MX-5 Miata
CONVENTIONAL BRAKE SYSTEM LOCATION INDEX
Fig. 1: Identifying Location Of Conventional Brake System Components
Courtesy of MAZDA MOTORS CORP.
AIR BLEEDING
CAUTION:
Brake fluid will damage painted surfaces. Be careful not to spill any
on painted surfaces. If it is spilled, wipe it off immediately.
2008 Mazda MX-5 Miata Grand Touring
2008 BRAKES Conventional Brake System - MX-5 Miata
2008 Mazda MX-5 Miata Grand Touring
2008 BRAKES Conventional Brake System - MX-5 Miata
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст