Mazda engine L8, LF, L3. Manual — part 14
B–36
ENGINE
Drive Plate (ATX), Flywheel (MTX) Assembly Note
1. Hold the crankshaft using the SST.
2. Tighten the bolts in the order indicated in the
figure in several passes.
Oil pan Assembly Note
1. Apply a continuous bead of silicone sealant to the
oil pan as indicated in the figure.
2. Use a square ruler to unite the oil pan and the
cylinder block junction side on the engine front
cover side.
AME2224E102
AME2224E555
AME2224E054
ENGINE
B–37
B
3. Tighten the rear oil pan bolts in the order as
shown.
Tightening torque:
20—30 N·m {2.1—3.0 kgf·m, 15.2—21.6
in·lbf}
End Of Sie
CYLINDER HEAD (I) ASSEMBLY
A6E242402000E11
1. Assemble in the order indicated in the table.
.
AME2224E056
AME2224E044
1
Water outlet case
2
EGR pipe
3
Valve seal
(See
4
Valve
5
Valve spring
6
Upper valve spring seat
7
Valve keeper
(See
B–38 Valve Keeper Assembly Note
8
Engine hanger
B–38
ENGINE
Valve Seal Assembly Note
1. Press the valve seal onto the valve guide by
hand.
2. Lightly tap the SST using a plastic hammer.
Valve Keeper Assembly Note
1. Install the valve keeper using the SSTs.
End Of Sie
AME2224E321
AME2224E302
ENGINE
B–39
B
CYLINDER HEAD (II) ASSEMBLY
A6E242402000E12
1. Assemble in the order indicated in the table.
2.
.
AME2224E046
1
Cylinder head gasket
2
Cylinder head
3
Cylinder head bolt
(See
B–40 Cylinder Head Bolt Assembly Note
4
Tappet
5
Camshaft
(See
)
6
Camshaft cap
7
Camshaft sprocket, Variable valve timing actuator
(L3 (with variable valve timing mechanism))
(See
B–40 Camshaft Sprocket, Variable Valve
Timing Actuator (L3 (with variable valve timing
mechanism)) Assembly Note
)
8
Oil control valve (OCV) (L3 (with variable valve
timing mechanism))
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст